Parker Yahoo Group Archived Messages

ID From Subject Date
591 Chris Peterson Re: Incorrect props installed by dealer/Parker 8/29/2005 10:36:00

Capt.
Make sure you are trimming that motor right to the top of the scale on
the yamaha gauges........
And trim tabs all the way up .... She should get right up and go!







On Sunday, August 28, 2005, at 08:35 PM, surfrat2parker wrote:

> Has anyone gotten a wrong prop from the dealer/Parker? I have 2004
> 21'DVSC with a 150 carb Yammie. The prop is a pro 14.25 x 16p and the
> motor will only do 4900 rpm @ WOT. My nearest Yamaha service (needed
> new fuel pump @ ~60 hrs and this year the needles in the carb swelled
> due to the ethanol @ ~116 hrs)said the prop is a more of a proformance
> prop and it should be the 15.(?)x 15p black steel prop on the boat. I
> was just wondering how many boats Parker is setting incorrectly from
> the get go?
>
> Does anyone have the same boat and motor having the same problem? If
> not, what prop are you using
>
> One of my trim tab actuators just went south. I kept blowing the fuse
> (10 amp factory installed) and replaced it with 20 amp as recommended
> by Lenco (website and manual). I called Lenco and they said it they
> were getting lots of complaints and they sent me a new one in less
> then a week. Evidently, water is getting into the housing causing them
> to sort out. I'm just waiting for a good day, most likely end of
> striper season (mid dec in ny) to change it.
>
> Tight Lines.
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>