Recent content by Jacks3420

I agree. I ordered ongaro unit hope it works Sent from my SM-N950U1 using Tapatalk

Hi all Need some advice. The motors on my wipers are afi 2000 made in the usa. The new afi 1.5 is same according to Marinco. However, one motor I replaced lasted a couple of months, other one DOA and last one burned out immediately. Voltage is good, these are now made in China and I think are...

These hold the window up better than two struts that come on each window? Sent from my SM-N950U1 using Tapatalk

These hold the window up better than two struts that come on each window? What about different hold heights? Sent from my SM-N950U1 using Tapatalk

Ok got it thank you Sent from my SM-N950U1 using Tapatalk

Am I using the wrong terminology. This is the flush fiberglass deck hatch in the cockpit not a window hatch. Sent from my SM-N950U1 using Tapatalk

I appreciate if anyone know which was the original gasket that is stick on for the hatches? Thanks Sent from my SM-N950U1 using Tapatalk

Ok thanks, yes it is a 34 Sent from my SM-N950U1 using Tapatalk

Thanks I appreciate it The genset is a fischer panda 6000 which is a piece of.... Anyways thanks for the info. Jack Sent from my SM-N950U1 using Tapatalk

I have a generator in my aft hatch in the cockpit of the boat. I noticed that the seal around hatch was gone. I was recently advised and added a weather stripping to the bottom of the latch to make it water tight to protect water from damaging the genset...probably used too thick of...

Thank you! Sent from my SM-N950U using Tapatalk

Hi all I have the 3420 and need some good value outriggers. Want quality but dont want to break the bank. Any suggestions on type and install location Thanks Jack Sent from my SM-N950U using Tapatalk

Congrats!!! Sent from my SM-N950U using Tapatalk

Thanks, Be in your area mid-April Sent from my SM-N950U using Tapatalk

Here she is Sent from my SM-N950U using Tapatalk