Recent content by viper8

Guessing you saw my ad, it was posted on both CP and THT. It sold a few weeks ago.

Not often, but maybe we could meet halfway, like Wilmington DE?

.

Nice, thank you for the follow up! Did you just through bolt them to the cabin wall? Also, what do you have your Hal-lock secured to on the gunnel?

For the past few years we have been using Penn fishing reels clamped to the cabin grab rails. I'm looking to add a set of actual teaser reels, or something with a higher rate of retrieve. How have you mounted your teaser reels on the Parker cabin? What models have you used?

Which teaser reels did you go with and where did you end up mounting them? For the past few years we have been using Penn fishing reels clamped to the cabin grab rails. I'm looking for a better solution.

Location is flexible. As I stated in the ad, I can meet in most areas of the eastern shore or or western shore of Maryland to make it more convenient for the buyer.

Sold

Thank you - I just posted some photos of the new rod rack in this thread. viewtopic.php?f=8&t=16569 _http://www.classicparker.com/phpBB3/viewtopic.php?f=8&t=16569_ Did you opt for the rear bench seat on your new boat? The previous owner ordered our boat with it. After much deliberation we...

Thank you for posting your photos and feedback. We finally replaced our 6 rod rack with a larger unit that we had built by a local fabricator in Deale MD. We had a completely new and wider rack fabricated in order to maintain adequate spacing between the rear row of launchers. We were able to...

Sold

Nice work! We have a 2820 with a TZT up front and have been considering mounting an iPad at the rear of the cabin as you have. Have you had a chance to use the iPad on the back deck? How does it do on bright sunny days? Also (assuming you did not connect to a power port) how long will the iPad...

We have been considering replacing the "factory" 6 rod rack on our 2820. I really like this setup. Can you tell me if the spacing between the rod tubes enough to accommodate 50-class reels?

Likewise- we mounted the wishbones as far forward as possible without interference with the bow rail. It looks like the bow rail effectively stops further forward on the 28 cabin compared to the 25. We're going to try to run spreader bars off the inner riggers and naked ballyhoo off the long...

Kevin, your install looks great. I consulted your multiple posts regarding installation before performing ours. As such, we took the same approach; stainless backing plates very similar to yours, and exterior starboard spacers for proper stowed geometry. However, presumably given the forward...