• If you have bought, sold or gained information from our Classifieds, please donate to Classic Parker Forum and give back.

    You can become a Supporting Member or just click here to donate.

2017 Parker 25’ SE w/ 300HP Yamaha and Trailer - LI NY

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

marktore

Active member
Joined
Jan 23, 2010
Messages
34
Reaction score
0
Location
Northport, NY
2017 Parker 25’ Special Edition, Center Console w/ 300HP Yamaha Four-Stroke. 80 Hours. NO Forward Seating.
Brand New 2018 Venture Commander Series 7300 trailer
Asking $68,000. Negotiable. Contact Mark, 646-261-3890.


LOA – 28’ w/ bracket. Registration shows length as 25’
Beam – 9’6”
Hull Draft – 15”
Deadrise – 16 deg
Fuel Capacity – 134 Gallons


Standard Factory Options

Compass
Horn
Raw Water Washdown
Stainless Steel Pull Up Deck Hardware
Stainless Steel Rodholders (1 Pair)
Combination Rodholder/Cup Holder (2 Pair)
Molded Anchor Locker On Foredeck
Hydraulic Steering w/Stainless Steel Wheel
Custom Accessory Panel
Trim Tabs w/Instant Retract
Navigation Lights (International Rules)
Cockpit LED Lighting (blue)
Bilge Pump w/Float Switch
Stereo w/Speakers (4 ea)
Rod Storage & Toe Rails Under Gunwale (4 Rods)
Full Transom w/Bracket (w/Swim Platform & Dive Ladder), Insulated Fishbox, Livewell & Transom Door w/ Access To Swim Platform
Self-Bailing Cockpit w/Contrasting Non-Skid Surface
Hull & Deck Joint Thru-Bolted (S/S Fasteners)
Heavy Duty Sport Rub Rail w/Stainless Steel Insert
Flotation Foam
10 Year Limited Hull Warranty

Additional Factory Options

Aluminum T-Top w/ Soft Top, Black Canvas & Rocket Launcher (X6) and LED Spreader Lights (X2 – Forward and Aft)
Bottom Paint, Blue

Options I have added once taken delivery

Birdsall Marine Original Rocket Launcher Custom Leaning Post, upholstery was done with factory Parker material and colors. Spradling Simtex Cream (077723) and Beige (077717)
Console and Leaning Post Canvas
Furuno FCV-627 Fishfinder, 600W max output
Airmar B60 Bronze, 12 deg w/ Temp (this is the transducer recommended by Parker for this hull)
Furuno 1715 LCD Radar – 2.2KW w/ 18” Radome, 24 NM Range on custom Sound Marine mount, powder coated white
Icom M424F VHF Radio w/ GPS Receiver
Spare power cables were ran to the bilge and up the T-Top for future needs. Both pathways also have drag lines for additional wiring pulls
Original 8’ Pop Up Bow Cleat w/ Parker logo was shipped loose from the Parker Factory. I installed two 10” standard cleats with ¼” aluminum backing plates for better dock line management and anchoring
The boat will come with basic safety equipment that was provided when purchased

Additional Information

The 300HP Yamaha has a 3 year warranty with an option to buy an additional 3 years. You have the option to extend the warranty up until the original warranty expiration date in late April 2020
20 Hour Service was performed by Whitewater Marine here on Long Island. Full service was just completed December 2017 by a certified Yamaha technician, this boat is ready to launch and starting fishing first thing in the spring
Burn Numbers. I fish so close to the beach and run the boat very slow for this type of hull/engine package. I like to run 18/20 knots and not much faster, in most cases I would run slower. The Yamaha LCD display shows me getting 2.4 MPG at 3700 RPM with a little trim tab
 

Attachments

  • IMG_4774.JPG
    IMG_4774.JPG
    109.6 KB · Views: 1,120
  • IMG_4952.JPG
    IMG_4952.JPG
    103.9 KB · Views: 1,120
  • IMG_5210.JPG
    IMG_5210.JPG
    96.5 KB · Views: 1,121
  • IMG_5630.jpg
    IMG_5630.jpg
    134.3 KB · Views: 1,122
  • IMG_5631.JPG
    IMG_5631.JPG
    121.5 KB · Views: 1,122
  • IMG_6379.jpg
    IMG_6379.jpg
    139.9 KB · Views: 1,124
I have a few people asking about the forward area and wanted to see pictures.

Here are a few more pictures, some showing the bow area. The one of the bow and the boat shrink wrapped was taken today, I was in there repacking all the damp rid containers. I have the porta-potti, it has never been used. It was removed as soon as I took delivery of the boat. Any questions just let me know.
 

Attachments

  • IMG_4978.JPG
    IMG_4978.JPG
    101.1 KB · Views: 986
  • IMG_7015.jpg
    IMG_7015.jpg
    43.4 KB · Views: 986
  • IMG_7021.jpg
    IMG_7021.jpg
    75.4 KB · Views: 985
  • IMG_7023.jpg
    IMG_7023.jpg
    58.4 KB · Views: 985
One time price reduction. Asking $68,000

She is still wrapped but I have a zipper installed if anyone wants to take a look. I will consider selling without the trailer so if your interested and don't need the trailer we can work that out.

Mark
 
Back
Top