ParkerSRQ
Member
Hey Guys,
Have a 1990 21 SE. About to install 18x12 Bennett Bolt Trim Tabs. I mocked it up yesterday to see where the actuator would mount and see where its going to come thru when I drill the hole for the upper hinge of the actuator. Sure seems like its going to come thru just above the floor in the battery box on the starboard side and same location on the port side where the oil reservoir is. Can anyone with a 21SE confirm this is where yours mounts and the wiring/hydraulic lines come thru?
Also.. fuel lines run down the port side and all wiring runs down starboard side from the helm. With the actuator coming thru in the box I'm going to have to extend the standard 6' wires that come on the actuator to get it all the way back into the bilge and across to the starboard battery box. I'm pretty sure I can't or shouldn't run the port actuator line from the helm to the port box.. wires near fuel lines? In case of chaffing
Have a 1990 21 SE. About to install 18x12 Bennett Bolt Trim Tabs. I mocked it up yesterday to see where the actuator would mount and see where its going to come thru when I drill the hole for the upper hinge of the actuator. Sure seems like its going to come thru just above the floor in the battery box on the starboard side and same location on the port side where the oil reservoir is. Can anyone with a 21SE confirm this is where yours mounts and the wiring/hydraulic lines come thru?
Also.. fuel lines run down the port side and all wiring runs down starboard side from the helm. With the actuator coming thru in the box I'm going to have to extend the standard 6' wires that come on the actuator to get it all the way back into the bilge and across to the starboard battery box. I'm pretty sure I can't or shouldn't run the port actuator line from the helm to the port box.. wires near fuel lines? In case of chaffing