Search results

I have a 21SE with a motor guide 24volt. I think my setup is just fine. I’m in Southern California and use the trolling motor fishing boiling rocks and kelp.

60+ miles to San Clemente island, Southern California in my 21SE.

My 2002 is 95 gallons.

I have Edison’s on two of my boats!

That happed to me also recently too after a water pump replacement. I found that I put too much grease on the shift shaft and that must have forced the grease between the male and female shafts? What I did was I used q tip to clean the grease out of the lower unit shaft, bolted it up, and it...

I have a 21SE with a Motor Guide Great White, 24 volt with a 60” shaft. I wish that I had the 72” shaft but the 60” works well fishing kelp lines and boiler rocks in Southern California coastal waters. I see no need for the 87” model! Go with the 72” motor!

I have the exact same boat, year and engine. I have 12x12 Lenco tabs that made a huge difference in performance in all conditions. I trim my engine up till it begins to cavitate and then drop down a couple of bars. I find the 150hp engine more than adequate for my 21SE. I have an Apollo 14...

Here is a photo of my Motor Guide Great White 24 volt, 60”. Works ok but I wish I had a 72” shaft.

I have a 60" Motor Guide 24 Volt Great White model. I think it has 84# thrust. I have two group 27 batteries under the console seat. When I ordered the boat, I had the Parker factory run a 1" PVC conduit from the console to the anchor locker. Wires are sealed in the locker to keep all anchor...

Post pictures of the leaning post without cover.

I have a 21se and was disappointed with the ride until I installed 12X12 Lenco Tabs. All the difference in the world. Just drop the bow and go a little slower and she will not slap!

I also have a 21se with a 150 2 stroke. Plenty of power for me and has a top speed of 41mph.

I have a 21se, 150 two stroke, that came with a Yamaha black S/S 15X17 prop. Did not like the prop at all! Sold it and bought a Propco , 14 1/4X15 # SSLYR15SP three blade prop. Performance is much better with a top speed of 41 with two big guys and half tank of fuel.Turns about 5200 RPM at wide...

I have a Formula 233 with a F250 and I run a Mercury Mirage Plus 17" pitch for heavy loads and see 46MPH at 6000rpm. I also have a Quicksilver 19" pitch for lighter loads and can get 48MPH at 5800rpm.

I used a company located in Florida called A&J welding. The person that installed the bracket is a Parker dealer and he said that my bracket is as good or better than the Armstrong bracket. The cost was about 60% of the Armstrong! custommarinewelding.com

I used thin rubber about the thickness of an old inner tube. Stopped the rattle!

Well, is the cavitation plate 3 inches above the bottom of the boat? Why should Evinrude talk with you?

Sounds like engine torque to me! I have three outboard boats and they all ride level at low speeds and lean more and more to port when more power is applied. Right hand prop rotation torques the boat to port. Opposite with left hand prop rotation! I'm a big guy, 245 pounds, and even when I'm...

Engine torque!