Recent content by 07vtgt

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. 0

    The biggest fish you ever caught

    Not a recent catch but an unexpected sailfish on my 2120 30ish miles out of hatteras. Pre-kids as my 2530 doesnt see as much fishing now that we are family cruising more than fishing. Cant wait till the kids want to fish too.
  2. 0

    For Sale 2001 Parker 23 DV CC - $35k

    Boat has 2 lifting strakes in the lift picture which I have always read on this site means it is a Deep Vee. 1 lifting strake was the Mod V boats from what I have read here.
  3. 0

    Underwater lights switch

    On my 2019 2530 they are tied in with the cockpit lights. If they are the factory lights there is a good chance they have stopped working. In year 1 I had my port side light replaced under warranty. Now in year 2 of ownership the STBD side light is now dead. I never needed/wanted to install...
  4. 0

    2520 with 500 HP

    My 2019 2530 has the newer bracket with twins on it that is stamped "MAX 300 HP/ENG" or something close to that but the sticker in the cockpit says "MAXIMUM 500 H.P. MOTOR". I am sure some would potentially try to argue that the placard is not plural as it doesn't have the "S" on the end of...
  5. 0

    Parker pilothouse Deck Shade

    I used a couple of metal closet rods that I put eye bolts through the top of and notched the bottom. This allows me to tension the awning for windy conditions. It goes over top of the rocket launcher and has reinforcement there. That gives it a little more height. My friend who has a 2120...
  6. 0

    How hard to install second station on 2520?

    Not exactly the same but I installed a bulkhead station on my old 2120 about 10 years ago. It was mechanical motor controls so involved switching to Morse controls inside and out. I would imagine FBW would be easier to do. Adding the second helm and plumbing it into the other helm was simple...
  7. 0

    Trailer advice

    The sticker lists weights in Kilograms and Pounds. The 12,760 is KILOGRAMS which is 5800 Pounds. As baker says, sticker shows 4700 Pounds for boat fully loaded out.
  8. 0

    Will 8 people safely ride on a 2120?

    I have done 6 adults and 3 kids on my old 2120 for fireworks with a short run and with the 150 you had to have weight distributed to get it onto plane. Also helped to have tabs fully down and motor buried. Too much weight aft and it becomes a problem. I would not want to run long distances...
  9. 0

    Inspection Pie Plate replacement

    As you spin the handle on top the little bar underneath (looks like a triangular head) that you can barely see at the bottom of the picture drops down and then you are able to pick the plate up a little bit, slide it to one side, then tilt it and pull the whole thing out. When you put it back...
  10. 0

    Parker dining table question

    Zooming in on your picture it appears your sticker is upside down compared to mine. It could be that on the older tables they used a tapered bushing in both the top and bottom holes and the pole could go in either way. My stickers specifically say tighten and loosen with an arrow pointing the...
  11. 0

    Parker dining table question

    I cannot say for certain it is the same but in the linked post you can see how the table in by 2530 is setup. Posts unscrew by hand out of the metal plate in the deck. Table sits on the lip of the front and rear seat and cushion goes in to make it a bed...
  12. 0

    Help identifying table pedestal

    The picture of the hole in the bottom of the black piece shows the threads. It does screw down for a tight connection in the floor before putting the table on top of it. I did not see any part numbers on anything for easy identification or ordering. Good luck finding what you need.
  13. 0

    Help identifying table pedestal

    Just went to the boat and took some pictures. I have attached. Sounds like the non marine versions and cheaper prices is a way to go. Based on my observation on the boat, the flange that screws on is plastic and riveted to the post. The flange seems to be square. Not sure overall how the...
  14. 0

    Help identifying table pedestal

    They look very similar to the ones on my 19 2530 with a dinette. Poles for my table have a sticker on them from Todd. I can try and make it to the boat and get more details or measurements maybe but that is my guess. Based on a google search here is what I was able to turn up. Looking at the...
  15. 0

    Removing Coming Pads

    On mine you do. There are 5 of them per side on the 2530. They look something like the picture attached. I dont know how many there might be on the 2320 as they are likely longer than the ones on my boat.
Back
Top