Recent content by gibby-up

Much apprecaited.

Would you mind sharing who fibricated the leanpost and the gelcoat work to the livewell? I'm in the Wilmington area and would like to make some similar upgrades to my SE. Nice touches and thanks.

Sounds good, we recently moved to the area although we have been in ENC the last 16 years. Look forward to meeting up and having a Parker outing.

I am interested as well and hope to make the trip up from Wilmington via the ICW.

Starling Marine in Morehead City recently listed a 23 SE https://www.starlingmarine.com/Pre-owned-Inventory-2018-Parker-Boat-23-SE-Parker-10689677?ref=list

On my 23, two of the four speakers are flush mounted in the console, below the helm facing aft at the livewell. Not only do they stay dry but the sound is much improved compared to prior placemnt on the side of the console. I'm not sure if the new conoles are set up to allow for this type of...

Agree wtih the above. I recently had my trailer overhauled with new brakes, hubs, hardware, etc. By the time it was all said and done it was not too far from replacing it with a new one. And sometimes less is more if you have been operating safely without the hassle of trailer brakes to date.

I have a 23se w/ 200 4-stroke. The tabs are great for balancing a load and leveling out at a lower planning speed during rough conditions. You can also favor the bow up in a cross wind. I rarely use the tabs if running the boat alone. But add a few extra folks and cargo, the tabs enhance how you...

Stainless clamp and mounting bracket to the leg of the lean post

Upon reviewing my post I realized it may have come off as pretentious. This was not the intentions with 13 year old boat. Plenty of good cover options out there.

Here is the finished product from O’Brian. Cover installs easy and obviously a custom.

My 23 SE is scheduled for a cover next week with O’Brian in Wilson, NC. Keep you posted as to how it turns out.

I purchased a couple of the single suction mount fly rod holders from bearsden.com Seem to work well for both a 6 & 8 wt setup.

Thanks for the suggestion. I plan to use some type of epoxy based product to seal the rough opening in both the transom and top deck. And leaning towards 3M's 4000 UV for re-bedding the deck hardware and fasteners. Appreciate the help.

Much appreciated. I found replacement drain tubes and definitely want to get the sealant right for the tubes and top deck.