Recent content by GMUGMU

Gary 407-4six7-8five53 I can call after 4 or you can text any questions. I've put the boat on craigslist at 39. thanks

The nuts are under the gunnel. Not easily accessible in the area adjacent to the middle of the front fish boxes. I suspect you could reach them via the anchor locker with the right wrench length. I think there would be one tough one on each side

thanks

I believe it is

thanks for reply

i believe the tank is original. I dont see any issues. no leaks or fumes. I replaced the gas fill and vent lines because they were a bit cracked

all batteries are less than 7 mo old and agm. about 2400 miles on trailer

there is a center seat as well. It hinges up towards the anchor locker. We removed it and still have it. We felt it was in the way but the next owner may want it

I will get a pic. It has forward seating with cushions. Raining here this morning

2000 parker 2300 2016 yamaha 300 4 stroke with 239hrs, installed late 2017 simrad 9" trailer new december 2020 24v ipilot 72" new install july 2021 (custom install, i'm proud of my work so be gentle :)) saltwater washdown large baitwell the deck and boxes drain overboard, never had any water in...

thanks for a good idea

I have a 2000 parker 2300 cc. I would like a new windshield. Is there a after market for these? thanks

I have a 2300. I used the fuel vent line. I taped an old piece of garden hose to the hull side of the vent line. I then taped my 6ga duplex to the taped hose connection. I pulled the fuel vent line in to the cc. I took the duplex tape off then used the old hose to pull the fuel vent line...

Roger that. BEP Cluster is added to the list. I can't thank everyone enough for the guidance. This forum is makes boating better.

I started this thread prematurely. As it turns out, my system is wired as your diagram shows. Once I reach a fishing spot and shut off the motor, can I switch to batt 1 or batt 2 to run livewell, nav, etc.? Thereby, leaving one battery full for starting motor? That is, if the switch is on...