I oftend wondered the same thing and in the past did some web searches. If I remember correctly, I done remember anyone actually trying just some people saying it wouldn't work. I believe there are some examples of the the 21 SE with a bracket although maybe aftermarket. I can't remember where...
The cutting board in this thread is similar to what I had in mind. I was thinking of making it much taller and actually somewhat over the outboard to keep the stern area open. This would also allow for a center rod holder.
Thats an interesting idea. I do see the Conchs have a splash well it mounts to. As you know the 2100 does not. I do think it would be cost prohibitive for a fiberglass shop to make a "one off" and don't think it would trailer well. It would take up a ton of room to be able to tilt the motor all...
Hello all! I'm looking for what your guys solution to a bait cutting board for a Parker CC with a notched transom. I was close to pulling the trigger (and still might) on some pipe work in the transom are from the rear jumpsuits and over the outboard. I could then also add a few rod holders ro...
I saw some where on the web that the 23'DV hull will now be the 24' and all composite. The 21'DV hull will be the 22' and all composite.
I make no claims to the validity of these claims. Just a rumor on the internet.