Recent content by jhill10110

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    SOLD!! 2006 2100 SE, low hours (Tampa, FL)

    It is sold! Thanks guys! Well I'm finally selling the boat I barely even got to use! I don't want to of course but its a 2006 with only 88 hours so obviously I don't get enough time to enjoy it. Warranty on the motor is good until 10/26/2008 however it can be extended for up to 3 additional...
  2. J

    Took the New 2006 2520XL Offshore !

    I've got an airmar tilted element transducer in about the same place and it works well at 30kts. I'm not sure what the problem could be with yours?
  3. J

    Tampa Florida Parker 2100SE

    I've got the Lenco 9x12 tabs with the position indicator. They work great! Last night I orderd the LED lights, I'll post some pictures when I get them installed under the gunwales :D I also have to say I love the way the F150 sips gas, especially these days!
  4. J

    LED Cockpit Lighting

    Oops, should have done some searching first. This thread answered my question: http://classicparker.com/phpBB2/viewtopic.php?t=284
  5. J

    LED Cockpit Lighting

    I just ordered the lights to start this project on my 2100SE. I haven't done any electrical projects on my boat before, what do you recommend for wiring and connections? Should I solder and then use a heat shrink tube or is there a better connector to use?
  6. J

    21 SE Trolling Motors?

    Good question! I have a 21SE as well. I asked my dealer about the Lenco troll-n-tabs and they told me they tried them for a while but got a lot of complaints and stopped recommending them. I wonder if this is still the case? I've also heard that the new extra long shaft Minnkota might work but...
  7. J

    Tampa Florida Parker 2100SE

    Greetings fellow parker enthusiasts! I picked up my parker last October, I've put about 40 hours on her since then. The "Linny Lou" is a 2006 Parker 2100 Special Edition with a YAM F150. I've added a T-Top, Jack Plate and Trim Tabs. My next project is going to be adding the under-gunwale...
Back
Top