Recent content by paddykiller26

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    2021 Parker 2320 and Minn Kota Trolling motor installation.

    Thanks for the info on this thread guys. I was able to contact Bob, (great guy) and he has a plate on the way to me that should be here Friday.
  2. P

    2021 Parker 2320 and Minn Kota Trolling motor installation.

    Thanks! I will give them a call again tomorrow and see if they will ship one out to me.
  3. P

    2021 Parker 2320 and Minn Kota Trolling motor installation.

    Looks great! Where are you guys moving your running light to? I just ordered the 100" minnkota quest and gathering parts now. Also, is 1/2" aluminum plate something I can cut clean with a jigsaw or is it best to have a shop do the work?
  4. P

    2520 trolling motor

    Beautiful install. Thanks for sharing.
  5. P

    2021 Parker 2320 and Minn Kota Trolling motor installation.

    Great job on the installation and thanks for the detailed writeup.
  6. P

    The biggest fish you ever caught

    I didn't weigh this bluefin I got a few weeks ago, but it is the biggest on my ride.
  7. P

    Access hatch placement

    Do you have a hatch inside the pilot house?
  8. P

    Access hatch placement

    It’s definitely a deep V with a notched transom. I’m not sure about the semi open bulkhead. I do have a bench seat and I know many don’t.
  9. P

    Access hatch placement

    You wouldn’t happen to have a picture would you? Did you center your hatch to the drain plug?
  10. P

    Access hatch placement

    This! I think I have a smaller cab and larger deck than others.
  11. P

    Access hatch placement

    Can you post a picture of your hatch? Is it centered to the drain hole in the cabin?
  12. P

    Access hatch placement

    I have tried reaching out to Parker multiple times for a schematic for my 2520 SLE with no luck. Does anyone see a bad reason to install a hatch here?
  13. P

    Notched transom CC cutting board ideas

    Here is what I did and it works great. I put my cutting board on a hinge so when the motors come up the board tilts with it. I have a leg in between the motors that the bar falls into to keep the board level and stable.
Back
Top