Search results

Its great to see the activity picking up here on Classic Parker but that unfortunately means the offseason. Lets see the off season projects and so far mine is new batteries but not yet....spring time I will buy them! Watch that little date sticker if you believe it.

Looking for Fluke and Seabass yesterday outside of Newport. I was bitten off clean with a 6oz Spro w/ squid after a big hit. Less than a minute later my son got another big hit and this is what he brought up. Only about a 3'er but a Mako. Successful release and he was pissed.

I removed the wiper motors last fall to clean them up. I got the starboard side back in before winter and now I have an issue with the way it is wired on the port side. Any help would be great.

For those who have a bunk trailer where do they sit on the bottom of your boat? Inside or outside of the strakes?

Trailer is in Providence RI area. Had my 2520 on it.

I have three different Garmin MFD's, 942sv, 942xs and a 943xsv. I have never installed the 942sv, the 942xs is installed but twice last season it froze for 1 to 1 1/2 hours so I got the new 943xsv not trusting it. I will put the new 943 in the cabin but having the other two units and wanting to...

I made the bad mistake of running my boat without the thrust washer for an entire day. The lower unit got beat up and torn into pretty bad. Anyways I replaced it and now have my old one if anyone needs parts.

I have a Garmin 942xs MFD that I want to hook up to my Raymarine Smartpilot X10 Autopilot. What do I need for a cord to have the two communicate? I had it hooked up to an older Garmin 2206 prior to the new unit. I believe it may be 0183 to nmea 2000 but not sure?

I have a Garmin 942xs installed on my boat at the helm now and just came across a good deal on a 94 sv which I want to mount beneath the overhang on my Parker Pilothouse being visible while out on the deck fishing. My question is will the transducers cause issues with each other if I mount them...

I want to add a second fuel guage to verify whats in the tank. I have a 2017 Suzuki 300 with the C10 display. I would like to add another for piece of mind. How would I go about wiring this? Thanks

Looking for a second remote waterproof unit to put below the overhang on the roof of my 2520 as a display while fishing. I have a Garmin 942xs and would like this display out on the deck. Any ideas?

I have a Raymarine SPX10 with a ST70 controller. When powered up it says Rate Gyro Fault. Pressing the cancel stops the alarm but "fault" stays in the top left corner of the display. Any ideas?

Have a 2017 Suzuki 300. What else do I need to do for the cold NE winter? Changed Motor Oil Chanced Lower Unit Oil Added Stabilizer, Ran For 20 Minutes Greased All Fittings That I Could Find Removed Prop, Inspected, Greased Prop Shaft And Re-Installed Prop What Else?

I just purchased two new batteries....Interstate cranking and a deep cycle. The two presently on the boat are fine just the cranking battery is four years old and the deep cycle is a one year old walmart battery I bought to get me thru the end of last season. Should I consider using all four...

I recently re-powered and have the motor cover as well as the prop off of the 2006 Yamaha F250. Here it is while I was removing the bottom paint from the transom prior too. Let me know if you need either of them and make an offer. The cover is in good shape and the prop is in great shape...no...

For an all in one unit GPS / FF / Plotter what do you recommend for the NE area? Looking in the 1 -2k range or so if possible for mostly inshore and some offshore

Tomorrow I will be buying a new 300hp Suzuki with a C-10 multi function color display for my 2520. I hope this is an improvement over my 2006 Yamaha F250. I am removing the bottom paint getting it ready for installation. Here are a couple of pics.

Would twin 150's fit on a 99 2520 notched transom? Looking to re-power with a Suzuki 300 but twin 150's may be an option too. Also what is the difference between all of the models? GXW, GXZW, TL? I presently have an 06 Yamaha 250 with 1900 hrs that does run great.

I am thinking about a new trailer for my 2520. With the NE tides I think I need a roller trailer and want to know the pros and cons of an aluminum vs. galvanized. I do want torsions rather than springs. Anyone have a roller alum trailer for a 2520?