Search results

What type of acid did you use? Also did you use the 3M Perfect it Gelcoat Light cutting polish and wax? I have used Shurhold buff magic in the past and may try something new.

Shurhold buff magic works great.

Thanks for the feedback. I think I am going to measure and see if I can squeeze in a 12". The layout on my 2310 helm is a bit short on real estate but may be able to fit one in. I was hoping to look at some stuff at the boat shows but they aren't happening this year so maybe have a summer...

I have a 2310 and would like to upgrade my Fish Finder/Chartplotter. Have you guys any recommendations to what size I should get? I am planning to flush mount it above the steering wheel. Is a 12" too big? 9" just the right size? 7" the way to go? Usually bigger is better but just wanted some...

Anyone know of a deck hatch that will fit into a standard size hole in the 2310 Parker - I think its 18"x18"? The acrylic is cracked and the two air struts are gone so I wanted to replace it. It had a Bomar part number 94070310 on it but apparently, that part isn't made any longer. Was wondering...

I replaced the tank on my 1995 a few years ago. The entire deck was cut and pulled out.

Fuel tank - fuel tank - fuel tank. I have a 95' and there is PVC pipe that runs below the gas tank to drain. Over time it weakens and can break thus leaving water to pool under the fuel tank. My tank developed pin hole leaks and spoiled the gas and basically ruined engine. I had to have tank...

I have a 1995 and had to put in a new fuel tank in 2018. The PVC pipe that runs along the bottom of the hull had broke and slowly the tank corroded by sitting in drain water and I kept getting water in the fuel and couldn't figure it out. Apparently there was pinholes in the tank. Its a chore to...

I purchased the Edson powerknob to upgrade my steering wheel. My question is where did you guys mount it? I was thinking mounting it at 1'O clock but thinking maybe 11 o clock may be better. Any thoughts?

I think I may just swap out the manual bilge pump to an automatic one so I dont have to worry about it. Good tips though!

Thanks for the feedback. I feel better that it happens to other boats and seems like its designed like that for some reason or the other. I will just have to hit the front bilge switch more often to pump water out. I am just glad there isnt some odd issue I need to figure out!

Got a question for everyone...I own a 23 walkaround and it seems like a get a lot of water in the front bilge area (you can access the area in the cubby on the floor under the deck plate. I have a manual switch bilge that I turn on and it runs for 5 minutes at time pumping water out. Where the...

Its a 1995 Parker.....no water misters.

Forgive me for the idiotic question - Just got a 2310 walkaround. There is a washdown pump at the transom. Is this pumped from saltwater or freshwater? I assumed fresh water since there is a water cap/fill on the starboard side of the boat and that must be the tank for the washdown since I have...

Its not coming in form the vent. I put on a brand new vent this year and its aimed towards the back so no water could possible enter there.

Yeah that sounds like my next step. I would think I would see or smell gas if tank was failing since you would think the gas is escaping somehow. I was hoping it wasnt the tank but thats where its pointing....still odd that water is getting into it though from somewhere!

Thought I found the issue of how water was getting into the tank with the bad deck plate seal but evidently that wasnt the cause...tank once again has water in it somehow! I am baffled. Tank must have a leak or something!!! UGHHHHH!

Total cost was $310. It was $165 for them to show up then they charge $8.00 per gallon of water/gas they have to remove and dispose of.

Those seats are actually too nice as my 23 is the walkaround with hard top so I need something that will withstand the weather being outside all the time and not in an enclosure. Springfield website is a huge help though.

That is a good idea! Thanks.