Neckbone
Well-known member
My Saturday project is going to be installing my new to me Lenco trim tabs, thanks to susqking who practically gave them to me. I just have a few questions before I start.
Does anyone have any good tips on installation? Do I need to wet out the small screw holes with epoxy before installing screws or will 5200 work well? I know I need to do it for the bigger hole I will drill to pass the power wire through. I plan to use 5200 to bed everything, partially tightening first, then letting the 5200 set up a little and then tightening it down.
Now for the switch. There are two different size wires connected to the switch. One is 12ga, and the other, I believe is around 16ga. I am planning on replacing them while they're easy to get to. My question is this. Can I replace the 16ga w/ 12ga wire? I already have plenty of 12ga, but would have to get some 16ga.
I think that's enough questions to start. And of course, I'll burn the memories on film.
Does anyone have any good tips on installation? Do I need to wet out the small screw holes with epoxy before installing screws or will 5200 work well? I know I need to do it for the bigger hole I will drill to pass the power wire through. I plan to use 5200 to bed everything, partially tightening first, then letting the 5200 set up a little and then tightening it down.
Now for the switch. There are two different size wires connected to the switch. One is 12ga, and the other, I believe is around 16ga. I am planning on replacing them while they're easy to get to. My question is this. Can I replace the 16ga w/ 12ga wire? I already have plenty of 12ga, but would have to get some 16ga.
I think that's enough questions to start. And of course, I'll burn the memories on film.