Recent content by Mike h

Warthog I've been using raymarine products since the still made missles I find they are user friendly to me and there customer service is top notch so I'll keep using and recommending them for another twenty plus years

Check out raymarine new axiom the 9 inch with nation is and chirp sounder is around 1600

I don't think you need to adjust it just run the strap like west coast nuts pictures show then if it's not rite you can adjust it

I fish those areas with a mod v when mine pounds I use tabs to drop bow or slow down a little

Welcome, if you call or e mail parker and give them the hid they should be able to give you a build sheet which will have your tank size and anything special when built

Thanks for the help

Here's the pic

Thanks but don't need to my boat has a tall transom I'll post a pic

I had that problem on my old boat if I rember correctly I just kept spinning the helm then it just popped I never had to bleed the lines

Ok thanks ,without being there I think my motor mount is above the waterline

Ok maybe I misread the manual I don't have a bracket and I don't want to paint the lower unit just the hull

Ok slight confusion,I was looking through my Yamaha manual and it said not to use bottom paint with copper does anyone heed this or is it ignorable?any input would be welcome

I fish and have a power down model on my 2520 ,when powering down I have to wait for the anchor to catch up with the rode,I don't see it impeding on my placement

Sorry I didn't pay attention to the dates on your post,but that's how I would have done it rather than sanding

For the hatches I'd remove the hardware and find a wood planer to run them thru, you can easily regulate the depth of cut and would leave a like new finnish