Yes, Lencos mount lower because the actuator mounts at full 12" cord on the tab. Bennetts mount at 9" chord as you can see in my pics so that pushes actuators higher.
Anyway... What a difference!!! Just got back from testing and its like a different boat. Only pounded once in 2' chop in tampa...
Well I didn't get any responses on this so I'm updating it to help out anyone in the future that installs Bennett BOLT tabs on a 21 SE. The thru hull for wiring on the upper actuator did exit in the back boxes about 1" from the floor. Everything looks good.. testing it out today on the water...
Hey Guys,
Have a 1990 21 SE. About to install 18x12 Bennett Bolt Trim Tabs. I mocked it up yesterday to see where the actuator would mount and see where its going to come thru when I drill the hole for the upper hinge of the actuator. Sure seems like its going to come thru just above the...
Brad21: The target bunks were on the trailer already, but I just put new brackets on and I'm getting them adjusted currently. They help a lot! Once the boat hits those you can drive it right to the roller on the winch.
Below is what Parker replied with. Sounds like its not much of a concern...
I posted this question on THT and received quite a few opinions on what I should do. Main consensus was to put the bunks directly under the stringers... but I don't know where that is exactly. I copied a photo from the projects section here showing a member who redid the stringers on a 21 SE and...
I'm posting this here because the website issues section hasn't had a post for years.
I have brighthouse at home and log on to CP fine, but at work (I own the company so it's not a firewall) I have brighthouse as well and I'm getting blocked.
My IP at work is 107.144.193.165
Can an admin...
Hello,
I was not able to use the frame after a tower was put on my boat. I have just the windshield installed now and don't need the frame. PM if anyone is interested. I don't even know what it's worth... $50?
Thanks
Justin
Do you know if I can take the T&T motor off without removing the outboard from the boat? The replacements seem to show a 3 bolt mount, but when looking at my OX66 I can only see access to two of the three bolt holes on the trim motor? Thanks for the help.
Thanks Dale and Merry Christmas!
I'm glad you told me this before I bought a new relay. I guess I will use jumper cables and bypass the relay straight to the trim motor. I should have the same intermittent up/down problem when wired direct so that would confirm the TT motor is bad correct...
Hmmm... just today... before I plugged those together I started having a trim problem. I'm getting clicking when trying to tilt motor up. But when I tilt down it works and then works when going up... seems intermittent. I'm assuming the T&T relay is going which seems very common from reading on THT.
Hello,
I recently purchased a Parker 21 SE with a 2001 225 OX66. While looking over the motor today I noticed a wiring harness that was disconnected and pushed down by the lower cowling. I plugged it together and definitely fits like its supposed to be connected. I have attached a picture...