Search results

Mount a good CREE LED under the bow pulpit...did that on my old 2120 Worked great

On my 2011 2120Sc I raised the well barrier 1"..Un screw barrier..Fill side screws holes..put 3/4 to 1" long pieces of pvc pipe under barrier at lower screw sites..use longer screws to remount in existing lower holes...re drill side holes...works great..also I mounted 2 rod holders on inside of...

The Edson SS knob is well worth the $

Capt Lou No pic and boat is in So Cal..I believe the Parker website shows it as an option..yes it is wider with real arm rests.. I can stand with seat in rear position and rotate more than 90* to port to watch rods..

I put the ladder back seat in my 2120 and love the back support. It sits on a seaspension post.. good clearance for rotating to watch rods when in forward position..

Thanks John Really well done...was considering a similar set up for "OMEGA lll" It looks like the same size factory bench seat as my 2120SC

:D Thanks Kevin I have been looking to do similar mod. Rick

:cry: Admin I can't open photos of this project by Horndog....HELP... Macbook & i Mac

KS I run a 2120SC and have been very happy with my Garmin 740s...s for sounder along with the Garmine HD18 Radar....I run a good 50/200 Htz transducer thru hull....works at speed...love the touchscreen..pinch the enlarge/ decrease , etc....mine is on a bracket...sometimes you just want to change...

2120 SC Open Transom Purchased my first Parker in 2011...a 2120 Sc...love the boat. I fish primarily in the pacific northwest for salmon, hali and tuna...run 20 -40 miles offshore without issues. Needless to say pick the conditions you are comfortable with. Lots of rough water..no problem for...

Sully...I have a 2011 2120...I raised the splash guard off the deck bout half an inch. Use PVC pipe between bottom of guard and deck where the screws that go into deck are. Also have two bolts on each side securing to each battery box. The factory set up except for the elevation...makes flushing...

Hi All Timely thread... I have a 2011 2120 with Parker rocket launcher / spreader lights. Can we switch out the halogen bulbs for LEDs ? If so any sources and part numbers. Hate to toss perfectly good spreader housings.

Robert I posted photo of my Seaspension here...I hope it worked

Recently installed (very easy) a Seaspension seat on my 2120 Sc then did a tuna trip out of Westport WA...pacific NW water.. Wow..what a difference...best mod since my Lewmar 700...all about comfort..my crew was fighting for helm time.. Call Greg Roberts at Seaspension 727 424 8254..tell him...

Give serious consideration to your wife's suggestion....could pay dividends in future "passes"

I made the chart bin....1/4" plexiglass, Starboard, longer ss screws into existing molding mounts...you can make it as deep as you want...just be sure to keep clearance for helm seat

Jacobsens Marine Seattle Wa

Sam...No cons..would NEVER again have a movable bracket..I have Yama 9.9 Hi Thrust T9.9GPXH Hi Thrust..Elect tilt. It's a long shaft..probsbly 20"...model # will tell all My bracket is mounted as follows: Center if tube is 12.75" below the black rubber rub rail...Top of square mount is 7 5/8"...

rloomis.. ...good point about a following sea..... Thanks to all for the input..

Good stuff...looks like I need to bring the motor up as part of the adjustment procedure... and yes it's always changing....