PKS1801
Well-known member
My 2000 1801 has a 3/4 inch Buck Algonquin sea cock on the thru hull. Apparently the shaft snapped because it turns and the ball valve does not. The pieces are shown in the following 2 links:
https://www.amazon.com/Buck-Algonquin-S ... in+seacock
https://www.amazon.com/Buck-Algonquin-0 ... n+strainer
There are no screws in the triangular base of the seacock and 2 stainless screws in the leading edge of the scoop. Anyone know how they are held together other than thread compression? 5200? I put the largest wrench that I could swing on top of the seacock but could not budge it with the limited pressure that I could apply through that huge access in the rear deck. Hoping for a call back from Parker tomorrow.
https://www.amazon.com/Buck-Algonquin-S ... in+seacock
https://www.amazon.com/Buck-Algonquin-0 ... n+strainer
There are no screws in the triangular base of the seacock and 2 stainless screws in the leading edge of the scoop. Anyone know how they are held together other than thread compression? 5200? I put the largest wrench that I could swing on top of the seacock but could not budge it with the limited pressure that I could apply through that huge access in the rear deck. Hoping for a call back from Parker tomorrow.