My 23 CC DV showing the Davit and the hull.
Located in Duxbury, MA. boat motor and trailer $29K or BO. deck is rhino lined and I needed to cut out the gas tank and replace with a brand new ($3K) 150 gal. deck had some attachment pads so I filled with 4200 and covered with rubber paint...need...
I have a 91 with a (i think 07) Yamaha 250 with 780 hrs... on a trailer with a davit and pot hauler (removable) for lobster pots, 4 swivel rod holders maybe 10 rod holders total. New 150 gas tank in 2021. rhino lined deck and bulkheads. was thinking about putting it up this fall for $29 or...
Good Chance, would you do this regardless of signs of corrosion? Where did you get the parts from and how did you learn the process?
I just purchased a 2008 F250 as well for my 23DVCC and it is a nice strong motor but I want to keep it for a while.
Thank you.
thoughts on a bracket...I ended up with a Yamaha 250 with the correct 25" leg....boat goes great tops out with a full tank of gas at 43 MPH. cruise at 26 turning 4000 and burn rate of 2.4GPH.
the only down side is the LOW LOW transom height. I will add a small filler piece for the short term...
I have the need to repower a nice classic 2001 23 DV CC that I got for my daughter to lobster our of and as my inshore boat. I need to replace the motor and have a good deal on a Verado 250 with controls and steering (I am kind of a Yamaha fan but). anyway it is a 30" leg.
SUGGESTIONS are...
Tank fabrication is done...dropped off Thursday - Memorial day weekend- picked up yesterday and under budget. 5200 Azek sleepers to bilge and 5200 on neoprene strips. need vent hose and new clamps and I will install and share more pictures.
New to Parker Member...picked up 2001 23 DVCC. Cut the tank out to replace ( not cheap $2700...what are you going to do).
People are talking about leaking tanks and having gas in the bilge...my tank is a sealed coffin no way to drain, I am considering installing a drain into bilge going...
new to us using it for my Daughter to commercially lobster fish in MA. cut out floor yesterday, sent tank to fabricator for a new one. Need to rewire everything. want to put a Davit on stbd side forward with electrodine hauler.
has anyone done any of those things that can shed some light on...