Recent content by JDesrosier

I'm trying PVC trim, well see if it is strong enough. If not I'll make it again out of starboard.

That's amazing, is there something on the other side? Did you through bolt that backing plate? That's exactly what I was thinking of.

All, I have a 2120 SC and spend quite a bit of time on the sandbar in Plymouth MA. I have a small rear anchor I am thinking of mounting under the gunwale. I was wondering if anyone has done this on the forum and had any pictures? Thanks.

Shrink wrapping isn't that hard. It was $200 for the gun, and about $150 a year for the wrap for my 2120 sc. It's a little sketchy because it sounds like a jet engine but one you do it once. It's not a big deal.

Where would I find the wiring diagram for my 2220 sc? I was having bilge switch issues. Where the bait well was on but the battery switch was off. I was curious if the bait well was accidentally wired to the float too.

That seems weird but maybe. That way you can turn everything off but keep bait alive. Seems weird to me but I'll chase it down. Thanks for the help

I have a weird one that I ran into. I washed down my boat the other day. I may have left the live well switch in the on position but definitely turned the battery switch off. Last week I had to go to airport and noticed the light in the live well was on. It had been raining that night...

Did you screw shelves into the hull or only the knee walls or support for hull?

I bought a new M2 mantis anchor but the anchor hung down and hit the winch every time I launched the boat. I bought the mantiss bracket and it just didn't fit quite right and still too low. Luckily my dad is a machinist and made these stainless brackets for me. I added the second roller...

Bought my 2120 sc at the Boston boat show 2 years ago. I have a 200 hp. Boat motor trailer it was around 86 k.

Hello, I have a 2120 sc and my driveway is pitched the wrong direction. I trailer my boat. Occasionally when it rains water will travel under the starboard gunnel along the shelf beside the helm and get the carpet wet in the birth. I am planning on sealing the pilot house to the deck, inside...

A generic plough ancor came with my 2120 SC, and I had a very hard time getting it to set in sand. I just purchased a 17 lb m2 mantis. Most of my anchoring is in sand. I'm in the cape cod area. Has anyone had any luck with the M2 mantis anchors? I think I went a little larger than needed...

I apologize if this has been covered already but I am curious if anyone has had good luck with any particular brand trailer slide. I have a 21 ft SC, and I find that I crank much of the way up the trailer so the boat sits correctly on the trailer. I use the boat several times a week and I...

I got mine June 2022 and I have over 80 hours. My biggest complaint is that the cabin is not sealed to the deck. Water can migrate under the wall of the cabin. My driveway is pitched the wrong way and my old cc would accumulate some water when it rained. Now the water migrates under the wall...

I think aluminum ribs would be better and cheaper than starboard on top. But that's just me.