The mounting bracket is 1/2 aluminum on the part that overhangs and one inch where it meets the deck. The backing plate is 3/8s. I did have to cut out a section of the forward bulkhead to allow for access. Glassed it back in after and readhesived the carpet.
Couple of updated pix. I decided to do a rail delete for ease of deployment and retrieve ( it helps that the boat is a 97’ that I’ve had over 20 years so no worries about mods).
Finally getting the new TM installed. Usually a DIY guy but I’m recently retired and relocated from CT to SC. Quickly became evident a TM was essential. So I contracted with Odyssey Boatworks for my motor, lithium battery and install. Chad from Odyssey has been a pleasure to deal with and...
Hi folks,
I have been running my 2320 SC DV for 17 years. Love the boat.This past weekend I was repairing a blown hydraulic line on my original Boat Leveler tabs. I have always wondered how the boat may perform with larger tabs? Any opinions?
I have the same model and vintage and notch transom with splash guard. Repowered in 2010 with a zuke df250. Yes it sits a little heavy in the stern compared to the old two stoke yami. Had to adjust bottom paint up maybe an inch. Never have a wet deck. I could prob shoot you a pix on how it...
I have a 97 2320 with an 07' zuke df250 , new to boat in 2010. Think it has 500 hours or so. Just put fresh water flush head on this season. Open notch transom. Had it the last 15 yrs, toying with a larger upgrade in the 32' range. 2011 trailer. Would be looking for mid 20s. South east ct area.
After not even going on the boat much for a dozen years, my wife flipped a switch and now enjoys the boat and fishing.
She would invite friends and the bucket got embarrassing. I pulled out the factory bench on the 97 2320 and installed a Dometic self contained head with external pump out. I...