the cabinet is through bolted to the bulkhead in three places..... through the 1/2 starboard board inside the cabin. Then you can screw what you want into that starboard. Dont mind how filthy the boat is..... getting her out of storage and ready to go... anchor holder is from boat outfitters
2019 2320. On trailer the bunks are 42 inches inside to inside.
that won’t work on a lift because the ibeams on the cradle are straight as the trailer axels are contoured. Thanks in advance
Why is there no grounding strap attached from the factory? I see where a ground wire on the valve can be attached too....where is the boats bonding system where is needs to be attached too?
I do not have shore power running to the boat but occasionally charge the batteries with a Noco installed...
I see no corrosion issues on lower unit or Armstrong bracket........
is there a "pin" holding in a flapper valve on the inside?
boat is in water for 2 months at a time then on a trailer for 2 months.....
I had a 150 hpdi (2 stroke) on the south shore of Long Island for many years (2003 2120). I never felt it to be underpowered. It was fine for what I needed it to do running all over the bays.... He is deff a little steep in his price.... how clean is the boat? how is the gel coat.... the...
Relocated the Fresh water wash down discharge on my 2019 2320. I did not like leaving it hooked up in its original location coming out of the molded step on the port side. Myself and guests have to board the boat from that side and it was only a matter of time before it got stepped on and...
Congrats on the new boat. I have a 2019 model.
Andy above is spot on about water coming in through the deck hatch on the anchor locker. Eventually I will have a new hatch made with out the finger hole and a custom cover for the windlass will help.
The pie plates on deck should need no...
had a similar cabinet on my old 2003 2120
this is on my new 2019 2320
made some upgrades.....
did some SeaDek as well.....
also added the swivel to the anchor so it free falls as it should (also check the rubber roller is spinning free, factory bolt was too short causing the roller to slightly...