Recent content by tomysel

I have a 2001 2520 mod v with notch transom and It fitted with a 30" shaft 225 ox66.. 4 years ago I replaced a lower unit from sei so I know it's a definite 30". From your picture it looks like you have a notch too.

Its been a while since i checked burn # but from what i remember seeing @ 4000rpm I'm getting 24mph against tide and 27 with tide and burning 14-16 gph... 2people, light fishing gear, 1/2 tank (60-70gal). My average is 1.6mpg. Its been a while since i recalibrated the standard horizon but...

On my 2520 I purchased a bimini off ebay for $120 or so new (comes with aluminum frame). I would get about 3 years out of the cover and change them out every couple years.. There is a picture of the bimini on my signature.

How many hours on the motor?

I too can't speak for the 2320 but if you were running a single 225hp on a 2520, most likely it was a mod-v. I believe all 2320 is a deep-v so I would think it'll have a better/smoother ride in higher speed in less then ideal seas..

Sent you a PM..

Looking to see if there is anyone in the tri state area still have their boat in the water willing to give me a ride? Thinking of buying one of these and want to get a feel.. PM me .. I'll can even pay you.. Thanks in advance!

I get sea sick when I go in the cabin when the boats rocking.. I'm fine in or outside when the boats on the move... Don't think theres anything wrong.. Just motion sickness.

1. Board name - Tomysel 2. Real Name - Tommy Lee 3. Boat Name - Chrissea 4. Hull Year - 2001 5. Model - 2520 MVSC notch transom 6. Engine brand & type - Yamaha OX66 2-stroke OB 7. HP - 225 8. Engine Year - 2001

I had the t-top extenders www.t-topextender.com . Negative is that it needs to be taken down before driving

Bus bar?

I added taco clamp on rod holders in between the holders. Can add 5 additional holder..

Depends on year and model... there should be a plate on the tank under one of the round deck plate. I have a 2520 mvsc with 14 degree deadrise 126 gal tank.

I purchased one SEI 3 years ago for my 2001 ox. So far so good no complaints. 3yr warranty compare to spending 3x much on yamaha rebuild with no warranty..

I plan on doing the exact mod when the old ox kicks the bucket. I too was thinking of leaving the notch and not closing it up..