Search results

Thank you for the responses, I have checked for water in the bracket and there is none. I have the ball type scuppers but have ordered the th scuppers as recommended. I think I will move the batteries into the forward cabin which should take about 175lbs from the stern and add 175lbs into the...

I have a 1994 2330 with a 2008 250 yamaha and I am getting water back through the scuppers and onto the cockpit floor. we are always standing in water when we are standing near the transom. Have any of you had the same problem and how can I fix it? Thanks in advance!

No, I sold it about a year ago

Thanks again Brent! This will make my 3rd Parker! A 2520xl; a2830; and now a 2330. I'm a Parker addict for sure.

Thank you Brent! Were you able to measure the width of the top of the cabin at the rear? /

Thanks Brent! I'll be looking forward to it. Also can you measure the width of the cabin roof at the rear? Thanks! -Leo

Hello, and thank you in advance for your help. I'm looking for a 2330 and would like to know the dimensions of the cockpit. A diagram of the boat would REALLY be helpfull. Thanks again.

Well, I went through an Armstrong Bracket replacement. Before you start this project be aware that you will have to cut a section out of the cockpit sole in order to reach the bolts that are hidden. Also be aware that the bolt holes will most likely NOT line up with the new bracket. Therefor you...

I'm looking for a pair of cockpit combing pads for a 2520 xl. I'm on the West coast but will pay for shipping from East coast. Thanks in advance!

Thanks Brent, I checked with them today but they didn't have it. I have a 2005 2830 but I assume that the 2530 uses the same molding.

Does anyone know where I can buy the edge molding for my 2830 table? I assume that it's the same as the 2530's. Thanks in advance!

Does anyone know where to buy the edge moulding used for the table in a 2005 2830? I assume it is the same as in the 2530 of the same approx. vintage. I have a 1" gap that needs to be filled. Thanks in advance!

Another great reason to go with an aluminum problem is that the load on your lower unit is much less when you go into forward or reverse. The stainless steel props are so heavy that in order to get them to start spinning when you put it in gear it puts way more load on the lower unit.

I can tell you the two things that will help you the most with your issue . The first is to install a set of transom wedges. They come in 5° or 7°. Either one will help tremendously. Yamaha outboard's have a limited amount of negative pitch and therefore the wedges are very effective. They...

I'm looking for a galley cabinet for a 2520xl. Thanks!

Hello everyone. I'm new to this forum and would like to say Hi! I have a 2004 2520XL modified vee. I have fished a lot offshore in the san diego/northern baja area and now live on the central coast of ca. The fishing and the ocean conditions are a LOT different here. Still learning!! I would...