soohoo
Well-known member
I have been having problems with the fuel sending unit for some time , I decided to replace it with a centroid sending unit .
When I removed the old unit one of the machine screws has been replaced by a large stainless wood screw .
My dilemma now is do I tap the hole to the largest size machine screw that will fit in the new sender unit's hole or some how put a nut and bot set up in with the bolt head inside the tank ?
The other issue I have is , I wanted to inspect the inside of the tank while the sender unit is out but how is this done ? I can only see a little bit in the tank and it looks like something is inside the tank is sliding around it looks like scratches all on the bottom of the tank . I tried to fit the go pro in but its to big
Thanks for the help Derek
When I removed the old unit one of the machine screws has been replaced by a large stainless wood screw .
My dilemma now is do I tap the hole to the largest size machine screw that will fit in the new sender unit's hole or some how put a nut and bot set up in with the bolt head inside the tank ?
The other issue I have is , I wanted to inspect the inside of the tank while the sender unit is out but how is this done ? I can only see a little bit in the tank and it looks like something is inside the tank is sliding around it looks like scratches all on the bottom of the tank . I tried to fit the go pro in but its to big
Thanks for the help Derek