Miss Mattie
Active member
When I launched the boat this past weekend, one of my Lenco trim tabs would not work. There was no motor noise when the port switch was depressed and the starboard tab does not move from the up position. The port tab activates from the starboard switch fine and goes up and down.
I suspect either a bad electrical contact, a bad switch, a bad motor or a combination of them. I have examined the back of the switch but all contacts seem intact and no obvious corrosion.
Any suggestions would be appreciated
I suspect either a bad electrical contact, a bad switch, a bad motor or a combination of them. I have examined the back of the switch but all contacts seem intact and no obvious corrosion.
Any suggestions would be appreciated