Recent content by Briand31

Correct Sent from my E6810 using Tapatalk

I would see where the cavitation plate is when engine is on plane. It should be at water level or just a little under if it's too far down then you could raise engine up a hole. You should also check and see what that engine's max rpm rating is, if it's not reaching max rpm at full throttle prop...

Yes, You can still use the original Yamaha shifter. If you see Westcoastnut on this site ask him to send you some pics he has my old setup. I believe I deleted mine Sent from my E6810 using Tapatalk

If you have a transom bracket as I do, I mounted mine to transom bracket on the port side. mine is a Kodiak tank. I can't get you a pic now as I am 3 hours away from it but could in about a week. Sent from my E6810 using Tapatalk

I have a 2006 2320 model several years ago when it had a yammi on it with mechanical controls I had to put dual switching boxes on it made by seastar solutions so I could still use the single lever binnacle. But since then I repowered with a Suzuki with electric controls that makes it a much...

Thanks for the tip Brent. I think I may have found the originals from new wire Marine, I believe the breakers are made by Carling and that's what they sell. Sent from my E6810 using Tapatalk

Anybody know where to buy circuit breakers or the switches for a 2006 Parker 2320 that are mounted on the dash of the pilot house. I've been having problems with my raw water pump and spreader light switches. I've cleaned all grounds and connections. Problems are intermittent. Sent from my...

I think we are getting a little off topic. Sounds like it's going to be a work boat, plus he wants to put a 2 stroke on. I agree if he wants a 4 stroke I would put a 300. But a 2 stroke 250hp is enough. Sent from my E6810 using Tapatalk

Sounds like what you want to do with it 250 2stroke plenty. Sent from my E6810 using Tapatalk

250 hp with a 4 blade prop or a 300 hp would be enough power Sent from my E6810 using Tapatalk

Unleased you said it. I've had a 2320 for 13 years and my yammi 4 stroke 225 never left me stranded in 2000 plus hours. Put a 300 zuke on it last year what a difference it made almost more power than I need. Sent from my E6810 using Tapatalk

Could be several things bad plug, injector spray pattern, coil failing, compression in that cylinder low, first off I would start with a compression test on all cylinders. Plug is rich seems to me that cylinder is not firing. Sent from my E6810 using Tapatalk

Instead of putting 2 engines on how bout putting a single 250 or 300hp on it they would be plenty of power for you Sent from my E6810 using Tapatalk

You have 3 problems, first off you should be at least running a 3x16x17p prop motor needs to be raised by at the least one hole and transducer needs to be moved off center. I have the same boat and motor that is the way mine is set up and I get 48mph at 5800 to 5900 rpms I still may raise motor...

I can't comment on the ride quality of a 25 vs 23, but I did install a 300 zuke last year and fuel #s and performance #s are much better with the bigger engine, doesn't have to work as hard. I did run a 225 yammi for 11 years Sent from my E6810 using Tapatalk