I am trying to get an idea on what would be a reasonable price for a 2013 2300 DV, 250 Yamaha, with 350 hrs on engine. Boat is in good condition and all has had service performed by Parker dealer/marina.
You guys have confirmed my worst fears.
So far the dealer has not been offered to fix this and I am sure that removing the x-ducer from its present location, patching the hole and then having the x-ducer installed in a location in the flat section as pictured above will cost me a bundle...
Thanks Guys
The latest Gamin update has been applied to the unit. All the connections are clean and have been checked both by me and the Garmin technical rep. All settings have been reset to factory defaults.
I do not know for certain that it is not the Gamin 7610xsv, I am basing my opinion...
I dove the boat last week and scrubbed the face of the x-ducer with a non scratching scotchbright pad. From what I could see there really was not any growth on the x-ducer.
I should also add that I have had both the dealer rep and the area Garmin technical rep out on my boat for a ride and to...
There are no appendages in front of the x-ducer. I am planning to get pictures of the hull and transom of a 2300 DV later today, which I will post when I get it.
As for when this problem started, I hate to say it but I'm not sure. Although the boat is a 2013, I bought the boat new in August...
I have a 2013 2300 DV, 21 degree deadrise, 15"draft, 8'6" beam, with a Garmin 7610xsv and an Airmar B75M 20 degree tilt CHIRP thrull hull x-ducer. This is a 600 W transducer with an operating frequency of 80-130 kHz; a beamwidth of 24/16 degrees. The x-ducer is installed on right (starboard)...
I read in another post that thru hull x-ducer should be bottom painted with a water based paint to prevent growth from interfering with x-ducer performance, for example with MDR transducer paint, see http://shop.mdramazon.com/TRANSDUCER-PAINT-MDR-720.htm.
When painting the x-ducer do you paint...
Does anyone know the best way to install the storage clips for an Armstong swim ladder on the back (outside) of the transom of a 2013 2300 DV. The storage clips have fairly small holes for mounting. Should the clips be mounted to the transom using bolts that go all the way through the transom...
Does anyone know what is the best bunk spacing for a 2013 2300 DV?
And does anyone know the bow eye to transom length of a 2300 (I am trying to avoid driving all the way to the marina to measure it and its not in the spec on the Parker site that I can find)
This would only be used for storage...
I have a 2012 21SE (160 hrs, now asking $30500) that I am selling and it has been on the market since last July and not sold. So I am thinking of getting a trailer and adding the cost to the sale price to help speed up the sale of the boat.
Does anyone have a recommendation for a moderately...
The Simrad NSS8 has a built in GPS and does not require an external antenna. quote from Simrad,
This feature loaded, fully integrated, 8-inch touch-screen chartplotter / multifunction display with built-in GPS and performance Echosounder, and NMEA 2000® network compatibility, puts powerful...