Recent content by jhendric

good news, thanks!

Guys I am contemplating replacing my fuel tank on my 2500 center console. As I am looking things over the console itself is rather large and all I can see holding it down are a series of fairly small screws on the inside. there's maybe 10 of them total. Can anyone confirm if this how the...

Would you be willing to put up some pictures of the deck from a bit farther out? I am contemplating similar and am curious exactly where the tank resides under the deck. I hear you on the cost of living in CA. I am in Northern California regularly, I honestly can't do the math on how working...

I installed the airmar B175C-HW this past winter. I have a 2500 CC (21 degree deadrise) Mine is in the same spot as the one pictured in the previous reply but on the Port Side. I got the 20 degree model. just make sure there are no through hull fittings or any other hardware forward of where...

10 4 thanks guys

yes, I believe mine are aluminum as well, just wanting to make sure they are not stainless.

one last question, are the square elbows made of aluminum or stainless? I may replace the anti-siphon fittings with open ones, want to match my metals!

huh...ok...thanks again

thanks!! what's ATF?

Guys, I posted this over on THT as well, but am interested in any thoughts or experience... I believe my fuel pickup on my 1996 Parker has become clogged. I am a bit concerned about cranking off the dogs on the top of the tank as they are good and frozen on. I'm wondering what your thoughts...

Making my own is interesting, I've googled the topic a good bit now an it does seem pretty simple as the bends are straight and vertical. Have you done this? if so any tips?

PS, can you tell me how much the windshield for you 1800 cost?

Thanks I'll check out UPD....as for it being rocket science, maybe not, but creating the vertical bends that would allow it to conform to the sides of the center console are beyond what I have in my toolbox.

Guys, the plexiglass windshield on my Parker 2501 CC is scratched and even cracked. I would like to consider replacement. DOes anyone know where I can source a new windscreen?

I believe Parker will sell you a tank that matches your boat...from there I believe Coal Tar epoxy before reinstallation is the preferred method.