Completed installation of GSD 28 Sonar Module. The challenge was finding a secure place to mount. Removed transducer cable from 8610 xsv and installed to GDS. I also installed a BlueNet 30 and port switch. I added a Satellite Compass and commissioned. Compass works great. I also tested sonar...
Hello. I bought 2 trays from boat outfitters on line then modified them. They come with two cup holders on each tray/ I only needed one so I cut three cup holders off and joined the two trays.
Swapped stainless steel nuts and bolts and replaced with aluminum grade. Purchased at McMaster Carr. Hopefully I’m good now. Warthog 5 thanks for saving me grief down the road. “Good advice is only good if taken”
Hey thanks for pointing this out. I just did a little more research on this and yes you are correct. I just picked up aluminum 10-24 screws with aluminum washers and will replace stainless steel with aluminum this weekend.
I bought 20ft of 2” Taco Metals Boat Rub Rail and 15 ft of Black Rail Insert on EBay. I fastened the rail closest to the transom (every 6 inches) using 10-24 SS bolts with nylon lock nuts. When I got to the corner I used a heat gun to soften the rail in order to make the bend. I had to use both...