Thank you for the responses, I have checked for water in the bracket and there is none. I have the ball type scuppers but have ordered the th scuppers as recommended. I think I will move the batteries into the forward cabin which should take about 175lbs from the stern and add 175lbs into the...
I have a 1994 2330 with a 2008 250 yamaha and I am getting water back through the scuppers and onto the cockpit floor. we are always standing in water when we are standing near the transom. Have any of you had the same problem and how can I fix it?
Thanks in advance!
Hello, and thank you in advance for your help. I'm looking for a 2330 and would like to know the dimensions of the cockpit. A diagram of the boat would REALLY be helpfull. Thanks again.
Well, I went through an Armstrong Bracket replacement. Before you start this project be aware that you will have to cut a section out of the cockpit sole in order to reach the bolts that are hidden. Also be aware that the bolt holes will most likely NOT line up with the new bracket. Therefor you...
Does anyone know where to buy the edge moulding used for the table in a 2005 2830? I assume it is the same as in the 2530 of the same approx. vintage. I have a 1" gap that needs to be filled. Thanks in advance!
Another great reason to go with an aluminum problem is that the load on your lower unit is much less when you go into forward or reverse. The stainless steel props are so heavy that in order to get them to start spinning when you put it in gear it puts way more load on the lower unit.
I can tell you the two things that will help you the most with your issue . The first is to install a set of transom wedges. They come in 5° or 7°. Either one will help tremendously. Yamaha outboard's have a limited amount of negative pitch and therefore the wedges are very effective. They...