Recent content by Miker1234

This is a great solution. I’m excited to add one in the near future.

Do you have a link to this on the site?

Yes, the rod holders on top of the pilot house. @Bodick93

I was thinking that too. The gap isn’t too big. I’m sure tightening the screws will get it to lie flatter. Thanks!

It’s aluminum. It’s either this option or using a wedge.

I have a similar setup for my antenna using a rubber wedge.

Should I add foam sheet between the rod holder and the fiberglass or not?

@warthog5 do you think I need the foam between the fiberglass and aluminum?

So I ordered factory rod holders from Parker a few months ago and just got around to test mounting them. There is a less than a .125” gap and the mounting surfaces don’t lie flush. I was going to mount the two if the three screws on the plates and the last one until it’s flush but I’m concerned...

That’s makes perfect sense @warthog5

I have a question about my EVO3s and marking fish. I went fishing today and we caught a ton of white fish, but none of them necessarily showed up on the down scan and sonar at 150+ ft. I had gps spots marked from previous trip and we’re drifting. I had the fish beep on and yet no beeps. Even a...

I just talked to my dealer and he mentioned to lift the bow of the boat up on the trailer slightly to prevent the back pressure build up and that every gas station is different. I’ll try it next time and report back here.

I have a 2022 and experienced it for the first time today. I’m able to fill it slowly but it takes very long time. I’m going to ready through this thread and see what I can do.

That thing is a beast!

Hey all! I was walking around my boat the other day and noticed a slight fuel smell on the outside on the port side of the boat. It’s a little stronger than what I’d expect from a vent, but it’s seems to be coming from the vent when I smelt it. Is this normal? Seems an obvious yes but I never...