warthog5

Good Move.... As to prop .... I have a 21pitch on mine... When I saw what the dealer put on it...It had me raising some eyebrows, as I...

Put sealant around the stud/ bolt on the inside of the Bracket tub. The Zinc MUST make metal to Metal contact. If it doesn't it will...

I would have a local shop fabricate them and use a heavier seat cushion. The OEM ones are pretty thin.

Back in 2021 I replaced the fill, vent and supply lines with Trident hoses from Defender. No sealant.

If your charging the battery /batteries.... Disconnect the TM from the system...You can do this by unplugging the TM or by tripping the...

Hi PeterParker, On our 2520 PH/300 Yamaha, there's a small black plastic mechanical 'lever'/sensor that sends the signal to the gauges...

ONLY Buy the OEM Factory Manual.... Not a aftermarket manual. https://www.simyamaha.com/search/?search_query=Manual

Never use 8ga for a trolling motor. Always look at what the manufacture says... and or use a wire table to get the correct gauge to...

ALWAY's check the Spark Plugs for proper gap ! If you had a water pup 100hrs ago..... Did you get a thermostat and Pop Off valve also...

You really will not be able to tell anything, other than, if the top of the tank around the sender is clean or dirty. And as Big Tuna said.

Time for paint. Awlgrip, Alexaseal or Tamco's AmerFlint II

I know for a fact that no 2820 boats have been made in anything other than deep v. They didn't add the D for a while because there was...

Nice boat but you’ve got 2 potential issues with a boat of that age that can have a huge impact on the price. The boat is nearly 20...

And a House Battery

Sorry.... I was thinking it was a twin engine boat when I asked that question... I see it's a single engine now.