Recent content by WW128049

2007 LoadRite 28T9700G2 Trailer. The trailer is galvanized steel, has tandem axles with torsion springs, 80 rollers and is rated for 9700lbs. The trailer carries my 2520XLD very well. However, I always trailer my boat full-time, so it has some wear and tear. The rollers and tires are in good...

I have one on Long Island (Suffolk County). I sent you an e-mail.

For planning purposes, I'm looking for the ball park cost for a professional (not me) to redo the non-skid cockpit deck on my 2007 2520XLD. Deck is in good shape other than non-skid surface being completely worn away. Boat is on Long Island, NY. Thank you.

On my 2520XLD, I had a 84” Rhodan for 2 years, but went to a 96” this year. The prop on the 84” would come out of the water too often for my liking when water was “bumpy” while spot locking in the ocean or sound. I’d definitely recommend a 96” shaft if you want to effectively use the trolling...

Good luck to everyone in SWFL recovering from Ian. I’m in Fort Myers Beach which was decimated. There are destroyed boats and cars EVERYWHERE; not to mention hundreds of homes completely washed away. I’m fortunate in that my higher elevation condo building suffered only minor damage and my...

The pump cartridge is easy to remove to inspect or replace. HOWEVER, make sure you close the seasick valve under the pump housing before removing the pump or water will come rushing in the boat. (This may have been obvious to you, but just making sure. 😉)

Brent- I finally installed the sidelights you sent to me. I originally thought they were made to be vertically mounted and that I would mount them on the outside of each side of my cabin. However, after seeing that the lights were made to be mounted horizontally, I had to come up with a...

Brent- I finally installed the sidelights you sent to me. I originally thought they were made to be vertically mounted and that I would mount them on the outside of each side of my cabin. However, after seeing that the lights were made to be mounted horizontally, I had to come up with a...

See from your picture that almost everyone one of the stainless steel screws in the seat base and door frame is rusted. Same on mine. Parker must not have used high quality screws. Kind of upsetting.

Yes, thank you very much again! Sorry for not advising you sooner. Boat is covered for winter 😢, so it will be awhile before I can install them. Hope you have a Happy and Healthy New Year.

My son and I did all the design and installation. I had a local metal shop cut the aluminum plate and powder coat it.

No guide ons.

Don't have top side pictures right now. Took off trolling motor and covered boat yesterday (snowstorm in NY today). I'll take send some pictures as soon as I can.

It is on a trailer and I never take the trolling motor off, except when putting the winter cover on.

Appreciate the pics. I ended up mounting mine in the same spot on the other side of the bow, but I had a larger mounting plate made. So, my motor stows outside the railing, parallel to the starboard side of the boat.