Help on tab swap

[montauk555]

I am going to do the tab swap from lencos to benetts on my 2320 dvsc .1st question,which size tabs,9x24 or 12x24? 2nd will the tabs interfear with a transom mounted transducer?Or how far should the tab be away from it?Thanks guys ,this site and the people on it are a great help!!

 

[Megabyte]

I can't speak to the 2320, but I have Bennett 24x9's on my 2520.

The boat had a P66 transom mount transducer at the time the tabs were installed, and there wasn't any interference.
I've since replaced the P66 with an Airmar 'tilted element' through-hull transducer, so that isn't even an issue anymore.

 

[John_Madison CT]

Megabyte: Does the tilted element transducer give you temp readings?

 

[Megabyte]

Megabyte: Does the tilted element transducer give you temp readings?

Yes, it does.

 

[Outta Here]

I have 12x24 Bennetts on the same hull as you. You'll have room for a transom mount transducer. Start the 24" tabs just inside of the hard chine (the first 4 or 5 inch offset at corners of transom). I'm pretty sure you have room for 9x30" tabs which might perform even better.


Love my Tilted Element. Completely eliminated all interference. IMO, one of the best marine products made.