Recent content by twh0924

Boat sold earlier this afternoon, thank you to everyone who reached out.

-2007 Parker 2320 Sport Cabin -2007 Yamaha F250 w/910 hours -2016 Load Rite Trailer -Armstrong Bracket with swim ladder -2nd station w/Morse Controls and tilt/trim for motor -Outrigger bases and poles -Full factory cockpit canopy cover -Lowrance HDS-Gen 2 -Furuno 1623 Radar along with custom...

Any updates?

Looking at the previous pictures, the motor is currently mounted fairly low so you should be able to raise her a couple holes creating better performance along with turning a bigger prop, say a 3x16x18.5. I know top speed is not a priority, but, by dialing in the motor height and then swinging...

Impressive numbers and it looks like you are running full of fuel as well. How'd your motor height look at cruising/wot speed?

Had a chance to run her with the new motor?

What prop are you currently, the 3x16x17, or did the Marina try the 3x16x18.5? I know you had said the 3x16x20 was too much prop as she was only getting 5500 rpms, but, it would seem as if the 3x16x18.5 would put you around 5900 rpms?

Boat looks awesome with that white Suzuki 300, I am jealous. Keep us posted on how she runs and loosens up following break in. Be interested to hear if you wind up tweaking the engine height at all and whether or not that helps. What motor did you have on before and what is the direct...

https://www.thehulltruth.com/boating-fo ... ratio.html

Very interested to know about engine height as well as prop. My understanding is that Suzuki's like to be mounted lower versus higher. Also, the 250 has a different gear ratio than the 300, might be a little difficult to compare the two as far as props go. I always wondered why the change in...

Marina took boat out for a ride today after the install of the motor they said it got 47mph at 6200rpm with a 3x16x17 prop Sounds good, curious what kind of weight load and also the motor height. Think you could use a 3x16x19 prop on there and squeeze out 50 mph?

I like it, this should be a very sweet setup, interested to hear how she runs with the 300 Suzuk.

If you go Verado, why not just the 350, it's the same weight as the 300, I think this could be an interesting setup!!

Bought a beautiful 2007 Parker 2320, former Barryville, this past weekend. Already got her setup with a new prop and she is running awesome. Looking forward to plenty of fishing and river cruises. Thanks again Barry, she is in good hands and I promise to take good care of her!!!

Any 2320's available out there?