Recent content by Bigbri

I’m about to do the same exact thing you did here. Wondering how it held up . Also did you have to use the high build primer ?

Here’s what I made for my 2520

It’s how it was when I bought the boat going on 5 years now and use it all the time. It Ts off the same valve that the macerator pump ties into. Never really noticed if it loses suction while under way.

Also my livewell pump is in the forward bilge

I have a definite break in the wire for the macerator pump which runs from the pump under the floor to forward bilge then up the rear of the port side, across the back above rear door, then down starboard side into the electrical panel. I can’t pull that wire out (way to tight) so I’d like to...

Has anyone drilled through the panels between forward bilge and storage compartment in the cabin in an 05 2520. I’m trying to rewire the head and the original wiring appears to go all around the boat and there’s a break in it somewhere. Would also like to use this route for née livewell wiring...

Looking to cut in a door on the transom of my 2520 Has anyone done this ? What’s the approximate cost? And how did it come out ? thanks.

I’m looking to buy a trailer for my 2520xl. But I only have a 1/2 ton p/u Does anyone tow one with a Silverado 1500 and how does it do ? I have a slip so I’ll only be going in and out a couple time a year. Also bottom painting from a trailer seems a bit tougher.

Thanks all for the tips. I think I'll just build a frame and put a tarp over it

Hello Just wondering if I should bother wrapping my 2520 for winter storage. I live in the northeast We get maybe 4' -6' snow per year. How many of you shrink wrap your pilot house? Seems like a waste of time and money but I'd like To hear other reasons why to Thanks.

Very good info. Thanks guys.

I have an 05. 2520. How much fuel do you is in my tank with one bar left on the guage? I feel that there is more than what is reading

brent, thank you i will check armstrongs web page.

hi guys, can someone help me find the right swim ladder i have a brackett with what looks to be 4 factory holes in it for a ladder i would like one that is telescoping. thanks

Where did you find that wiring diagram? I would love to have one for my 05. 2520xl