I was thinking the same one straydog used. What’s your thoughts on the brass?
Great idea! I’ll try it. There is not much standing water in my bilge but I’m going to put the bow of the boat up in the air so anything that’s left in that very lower from under the tank comes out the back
With almost no access I managed to get 2 holes drilled for brass scupper tubes and plugs for future drains. Slightly damp foam at bottom but looks like most drained out 🙏👍
It’s not AC but works. Seen a few local guys put this in the bow in front of the portapotty.
https://www.icybreeze.com/?gad_source=1&gclid=Cj0KCQiAv8SsBhC7ARIsALIkVT2Gx9xUg4jfJBryndCqqbisf8XDibK8YsKDuhoQblzIYx83X4KGqB4aAmX4EALw_wcB
I’m kinda off thinking the same thing except I did a core sample of foam that was soaked from 3” below the top of the tank and it’s now bone dry and powdery. Hoping that means most all of it can dry and give this tank a good number of years to go.
I’m also installing 1” drains into the bilge.
The water is from when the bilge filled with rain water months ago and I had all the pumps and hoses out and drain plug in 🤦🏻♂️ We had 3 days of crazy rain.
Update. I did some research and it seems as though the PVC pipe from the anchor locker is the lowest point on the boat under the fuel tank. So after drilling a access hole I popped a 3/8” hole into the wall separating the gas tank from the bilge and boom water gushing. Hopefully this fully...
Window did not want to remove. Got the lower trim off and someone 5200 the window in so I 4200 the outer perimeter so hopefully the problem is solved till I want to surgically remove the window itself.
After washing the boat I noticed the window above the sleeping birth on my 08 2320 leaks. I took all the screws out top and bottom and it doesn’t want to come out. Anyone have a schematic or resource for this?
It’s original Parker on the deck station. I went and got the boat and on the trailer the steering works so I’m at a loss. Going to float it Sunday and see if I loose steering under hydraulic pressure.