Recent content by chuck fluke

Ok I see that. But factory wire digram shows the Diode that run from fuse to switch?

Hi i need to replace a inline diode that goes from my Breaker to my Bilge Switch. The breaker is 10amp. What size Diode would I need?

Yes I have two bilge pumps one in the cabin area and on in the rear stern area.

Hi Yes I have a pump in the cabin area under the plate and I have a bilge pump in the rear of the boat. They were in there when I got the boat used. I had a bad float switch, going to buy new pump and switch.

Went down to my 2120 Parker 2003 and when i turn the two battery on i notice some smoke in cabin. Found out that the front bilge pump or float switch wire was hot. I cut that wire and everything was good. Rear pump works and boat runs fine. Think front pump may have a short? Also how are the...

Hi Guys I need to replace my fuel tank vent that comes out from the side of the boat. The other day a piece of it broke off, must have hit the side of the dock. Is there a easy way to access this vent? It looks like I have to take the seat out on that side to get to the vent? Can I make a access...

Hi Guys Im have a 03 2120 pilot house and I have some soft spots around the both deck plate area. I want to cut out the deck and replace it. Also more then likely replace the tank while I have it open. Is the deck screw in at all? When you cut the deck will it come off easy? Any info would be...

Hi Ron Thanks for the info. I purchase that line and chain already, I needed new anchor line when I got the boat this season. And that is the windlass that I was planning on buying. Here is my e-mail address. [email protected] Thanks Ron the pictures will be a big help

Hi Guys I have a 03 2120 Pilot House and I want to put a windlass on it but the boat came without a pulpit. Can I just put some type of Bow Roller on the front and move the nav light? Any help and pictures would be great. Chuck

Hi Guys I have a 03 2120 Pilot House and I want to put a windlass on it but the boat came without a pulpit. Can I just put some type of Bow Roller on the front and move the nav light? Any help and pictures would be great. Chuck

Hi Guys thanks for the help this info will help when i do this project after the fishing season Chuck

Hi has any one repower a 2120 pilot house with a Yamaha 200 4 stroke 4cly. Want to find out how it performs on this type of boat. What type of top end speed and rpm.

Hi Guys I have a 03 2120 Pilot House that I just got this season. It has a 2 stroke 150 6 cylinder . I want to put Hydraulic Steering in it and I want to repower down the road to a 200 Four Stroke. Can anyone tell me what type of system to get that will work on the 2 stroke as well on the four...

Well got that gauge working. It was a bad ground plate I change the plate and put all new heat shrink connectors and all is good now.