Recent content by Dawgs

thanks guys. I will take a close look at the gaskets and see if that the issue

Parker 2520 I have a leaky deck/hatch/window on it. The window I'm talking about is the overhead window/hatch in the cabin underneath. I'm not sure where exactly its leaking from. I siliconed it pretty good hoping that's the issue but its still leaking. Is this something that happens often...

I'm in the process of swapping out my old Lowrance FF/Plotter for a Hummingbird. I have a Lowrance fuel flow sensor installed on my old system. Can I use my Lowrance fuel flow sensor on my new Hummingbird system? Or do I need a sensor specifically made by Hummingbird?

Parker 2520 I purchased a gps trolling motor to install during the off season. I have seen a few mounting ideas but my question is this. Has anyone ever mounted a TM on the pulpit. I was thinking about removing the anchor and storing it in the cabin. (I rarely use the anchor anyway). I'll...

Is it possible to run the TM with a plotter so I can just tap "start point" and "end point" on the plotter and the trolling motor does the rest?

I'm in the market for a trolling motor for my 2520. My primary plotter is the Garmin 94sv . I also use Lorance HDS7 as my back up. any recommendations? An guidance would be appreciated Thank you

ok went to change the high pressure filter. When i went to remove the cover all 3 screws were pretty loose. Replaced the filter and tightened it up. Ill take it for a ride later fingers crossed

Didn't get a chance to take it for a ride yet but the pick up came right out and was clean. Nothing left on the tank side of the ball. Looks like its the motor side. Filters?

high pressure fuel filter hasn't been changed yet

yes .. started when full. 1/2 now and still does it

Vent is clear Bulb is not vertical but never was Fuel filter a few months old Seperator a few months old Vent is clear Anti siphon brand new Unknown about the pick up screen. I'm afraid to remove the pickup

1995 2520...2003 Honda 225....I'm having fuel starvation issues. It high rpm the ball collapses and the motor boggs down. I replaced all the lines from the motor to the tank. I switched from 1 existing pickup to the other existing pickup. Same result. I'm sure it's possible that both pickups...

I'm looking for the teak step gunnel plates for my 1995 2520.

I thought I bled it good. Hopefully that the problem. I has steady steam of fluid coming from the bleeder. How do I insure all the air is out?

I have a seastart steering system. I just replaced a hydraulic hose from front helm to rear helm . filled and purged (i think) now i can only turn the motor to one side then it locks up. I would have to open the bleeder and manually turn the motor to get it back. Then it would do the same...