Recent content by gw204

I have the SS console rail off of my old 20' Grady. Will try and get some measurements and pics for you this weekend.

Glass in a piece of core, gelcoat and then cut the proper size hole.

I tried silicone plumbers grease on the deckplate o-rings on my old Maycraft. Tube said it was safe for use on rubber. That crap hardened up in matter of months. :(

Looks like you could pivot the roller bracket up and get a more straight line pull.

You don't have a boat holding tank. That plumbing is for a remote pumpout. Part 4b. http://www.thetford.com/part/porta-potti-260b/

Still no beer. :wink:

Just went thought the same thing with the trailer for my old Maycraft 1800. Original springs and axle lasted almost 15 years so it wasn't worth the additional expense to me to go torsion. So I purchased new leaf springs, new bushings and a factory replacement axle. Before mounting I soaked...

It's certainly up there. I think I've seen mention of 3 in the 10+ years I've been on this forum. The only other ones I can think of that might be more rare are the straight inboard 2510 and there was another 25' that looked to have a bolt on cuddy with the helm mounted right to that, no...

Today marks the end of the Maycraft project. She was sold and delivered to her new owner early this morning. Anybody got a 2330 sitting around they aren't using? :)

Please explain to me why there are no beers in any of those photos. Fail. :D

If that were my motor I would definitely have it checked out before I continued to run it. You could spend $$$ now....or $$$$$$$$$$ later.

Don does great work. He did the t-top and leaning post on my old Grady CC. Buddy of mine has his Grady Islander there now for a new hardtop. Boat looks awesome!

It's not very noticeable in the pics but the windshield looked pretty ratty, so I pulled it off to see if I could freshen it up a little. I had an old Meguiar's headlight restoration kit in the garage that contained 1000 and 3000 grit sanding pads, some Plastx cleaner/polish and a buffing...

Stuck in a new fuel tank sending unit and pulled new wires from the sender to the console. Stupid gauge still only swings between full and super full, so I think it needs to be replaced too. Then I fogged the engine, gave her a quick bath, took some pics for a Craigslist ad and recovered...

Probably a lot like this kid... :D