pelagic2530

Unless you’re dead set on the Parker branded ones, I’ll put in a good word for the solid stainless Mate Series combo rod/cup holders. I...

Just so you know... this is not just a Parker issue. I'm a marine surveyor. Can't tell you how many times repair shops and owners have...

That same joint in my ‘97 1700 are through bolted with nylock washers. If you have access to the back side, that’s the way I’d go.

Welcome to the area! I’m out of Indian River Inlet. Just getting home this week from 6 months overseas, looking forward to that same...

I originally started out thinking I would use the two 1/2” spacers up top but as it turned out it was better to put one on the inside...

Is the “timing out” consistent? Do they turn off at the same interval each time?

Well you can.....just takes up more room having more than one boat.

Looks good. The larger plastic piece goes underneath the canvas, correct? If so, I’d recommend you radius the corners a bit more to...

Starboard sits atop the aluminum. Top of aluminum not finished. Cable clams to go on top of canvas. Bottom of aluminum which will show...

The Garmin radome is not super supportive of having the cables run down beneath the dome. See mounting instructions here...

Use some split-loom conduit to protect the cables from UV rays. The conduit lasts a few years before it gets crispy and needs to be...

The only way you’re going to get Clear and SideVu is via the addition of a new transducer that supports those features. In your...

I think this sounds like a great install plan that I bet you’ll be very happy with. Probably a better solution than relying on plastic...

Measured to the outside of the two flats welded in from the factory it is 27" I took a digital angle gauge, zeroed it at the center of...

Very nice! What sort of survey work are you doing with her? I spy a transducer pole mount.