Recent content by Pipedream

Did you use a pipe wrench or a 1/2" ratchet? I brought a 1/2" ratchet down but needed a short extension so the square will bottom out out. I did not want to damage the end cap with the square partially in. I am able to use winch to retrieve the anchor . I break it free next time I get back to...

Went down to the boat today and tried to free it up manually ,with no luck. I will bring two long handle 1/2" ratchets next time. That thing is locked up tight. I put plenty of lube on it, just didn't have enough leverage with the little wrench that comes with the winch. I took the stop off and...

Thanks Lucky John, I will give it a try. I haven't used the anchor since May. I will let know if it works in a week or so.

I tried to drop the anchor today. It started to release and stopped right away, I toggled up and down a few times and it popped the breaker. I tried again with same result. I didn't have time to work on it today, but will be back down in two weeks. Has anyone had a similar problem?

Sorry my phone was off when you called and when I replayed your message I accedently erased your message,and your number. Could you call me again, thanks.

I have a 2009 2510 XL Bought new in Nov 2010 , fished 4 seasons YAM F-250 (420hrs) Raymarine C120w MFD Raymarine digital radar Raymarine Auto pilot Pro fish 700 electric winch Electric flushing head 16 rod holders Coaming pads Two new batteries, bottom paint 8000# aluminum bunk trailer new in...

I talked to Eric at Parker and said the main stringers on the boat were on 30" centers and to move the bunks to 30" inside to inside for the best support. The trailer is a Venture 8000# duel torsion axel with 4 wheel disc brakes. I will let everyone know how it works out.

I was going to tell you every thing was great with my pro fish 700 untill I went out monday. I had a problem yesterday, the clutch would not close tight on the rope and retrieve the anchor. I think this was do to operater error. I had the manual on the boat. After reading the manual I noticed...

Thanks for the number. I wont be pulling the boat until mid Dec. but I dont want to have to make any ajustments when its freezing cold out.

How far apart should the bunks be on a 2009 2510xl 16 degree hull? I picked up a new trailer and the bunks are spread out all the way. They are 51" outside to outside and 45" inside to inside. Thanks for any info.

I replaced the zincs on the trim tabs and the one above the prop. The marina didnt replace them before they put the boat back in. It took a little skill and patience to install them hanging over the sides of the swimm platform. The trim tabs are unpainted, but they didnt have any growth on them...

I will have to ask the dealer ,I dont Know if Parker sends them out of the factory with zincs or if they put them on at the dealer. I will ask them about the round zinc that appears to missing just above the prop on the horizonal fin. I guess It was never installed or became loose an unscrewed...

The trim tabs on my boat are not painted . They did not appear to have any damage but they are brand new.

Pulled the boat out thur befor the storm. I had it set on a craddle at the marina and I am glad I did. I went down today to check on her and the zincs on the trim tabs were almost completely gone after only 4 plus months. Also It looks like there was round zinc on the lower unit just above the...