Recent content by pparke

Have a 2003 if interested

I have a 2003 2510 and am ready for a possible repower as I like to go far out and need the speed. My current 225 is ok but again I only go on calm days so would like the piece of mind of new power with more speed. My Parker has a max HP plate of 325 on the boat. I don't know if I ever seen one...

I am thinking about repowering from a F225 to a F300 on my 2510. Can you give me the name of the company you used for the repower and are you happy with the job. Thanks, Paul

I am thinking about repowering my 2510 from a F225 to a F300. Could you give me the name of the person you used for your repower and are you happy with the job. Thanks

I also have one that works great at 10 mph +speed but you cannot troll at slow speed with it.

I have a problem with the overheat alarm. It only happens at low rpm in a trailing sea. The pisser tube is not flowing hard like it should so I replaced the water pump impeller but it made no difference and the impeller looked fine. I am Thinking that the theromostat might need replacing. What...

I am thinking about purchasing a trailer for my 2510. What model and size should I get?

Thanks for the help and advice. I went in the water yesterday and put the tabs back on using a coathanger for now and added zincs to the tabs. I hope this will last until I either get new tabs or new pins. I really dont want to pay for a haulout in the middle of the season. The old pins has...

no they did not but zincs are close on the motor and bracket

i just purchased a new s1000 and installed it as recogmended . I installed it behind the stearing station on my 2510 inside the fiberglass electrical box. The problem is that when I am standing at the rear of the boat 8 feet away the system looses signal from the remote and it goes into...

I up graded my trim tabs with 12X18 blades on my 2510 and the other day I noticed that the port blade was dangleing. After further inspection I found that the hinge pin was gone. There was a rust stain at the hinge. Did the pin rust away, the tabs are less than 6 months old. Did Lenco not use...

Fish Pimp, How much did you spend on the components? I was thinking about one but not sure if I can afford it yet.

I found some water inside one of my tabs and want to replace the motor before spring dump. does anyone know of where I can purchase just the motor. Lenco only wants to sell me the whole new actuator. Thanks, paul

I came up the bay the other day in 17 to 25 knot winds. The boat took a beating and so did I but the boat took it and got me home. I think the boat can handle more than me.

I ended up taking the sending unit apart and found debris that was very small. I cleaned it up and put it back together and it works fine. I ran the boat to Norfolk and was amaized at the difference in mpg due to sea conditions. The best I could get was 2.4 mpg at 4800 rpm. The worst was around...