Lee Outrigger Installation

Shop deals on ebay
shop deals on amazon
Advertise with us
Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
A

ABRIG005

Well-known member
Joined
Nov 18, 2008
Messages
101
Reaction score
0
I have a 2120SC and about to install the outrigger bases. Is there a sweet spot to install the bases for 16' lee outrigger poles? Thanks Anthony.
 
roof top. i forgot the model number off hand but its the 1.5" ones that have the push button that locks in place. thanks!
 
I think I posted these before but see if they help. Model 2530 same bases.

Base1.jpg


Base2.jpg


P9160255.jpg
 
ok do you find them adequate without the shims to level them? first time installing so i want to make sure i dont f them up to bad.
 
I'd shim them ...

See taper needed on my rooftop mounts

rigger1_137.jpg
 
The previous owner installed them but I like the clean look without the shim.

I actually put a bungee between them on the first eye in the up position to take pressure off the bases, works well. That takes a little of the offset out but honestly I don't think it is worth it. Matter of preference I guess.
 
what is the best material to make the shims out of? where can i buy it? thanks for all the help!
 
You must log in or register to reply here.

Latest posts

Back
Top