In December I had the bottom of my boat soda blasted. I plan to apply the Interlux barrier coat before I apply Micron CSC. Have any of you done this project? I am concerned about sanding prior to applying the Barrier Coat. Should I sand by hand our use a palm sander? I welcome your advice.
Interlux Barrier Coat
- Thread starter Parker
- Start date
Help Support Classic Parker Boat Forum:
My yard did mine as they don't allow certain DIY procedures... and that was one of them.
They used a DA sander to give the hull 'tooth', then washed it with solvent to remove any release agent that might have been left.
Barrier coat (2 coats I believe), then 2 coats of Interlux Micron CSC.
So far, so good!
They used a DA sander to give the hull 'tooth', then washed it with solvent to remove any release agent that might have been left.
Barrier coat (2 coats I believe), then 2 coats of Interlux Micron CSC.
So far, so good!
jpg1969
Well-known member
Brad,
I would think you could just hand sand with 80 grit to clean up what's left after the soda blast. I followed the Interlux guide for the interprotect 2000 (5 coats plus 2 coats of Micron Extra) to the letter with excellent results. Here's their guide which we found very helpful.
http://www.yachtpaint.com/USA/boat_pain ... rotect.pdf
I would think you could just hand sand with 80 grit to clean up what's left after the soda blast. I followed the Interlux guide for the interprotect 2000 (5 coats plus 2 coats of Micron Extra) to the letter with excellent results. Here's their guide which we found very helpful.
http://www.yachtpaint.com/USA/boat_pain ... rotect.pdf
