Recent content by raysbigfish

I have 2 Marinco Wiper Motor 1000 Series both single speed, i wouldn’t get the benefit of fast speed, correct?

Will this setup synchronize the two wiper motors?

Hopefully when you get the motor running, do yourself a favor, and replace your water separator from the original 10 micron filter to a 2 micron (S3220SUL) it fixed 90% of my problems.

Does anyone know where I can get the trim molding on the deck. 1 inch in the front, and 1/2 inch in the back area. Two different sizes . Thanks

I have a 2002 2510 deep V , I just installed a Fruno dff1-uhd , and I am getting some interference on the screen. I was told to ground the unit to ships ground. Can someone please tell me where that is . All I have is powered to battery ground. Thanks

I had these aluminum plates made, then anodized

I think that’s my best bet , to contact the gas tank manufacturer. Thanks for your help, appreciate it.

The only hatch, is for gas cap hose to tank , no access to anything else

I just filled it up. It’s 160 gallon tank. My boat is a 2510, so it used to have the big box looking seat base. But at some point, they were replaced with a plate and the shock seat mount. I don’t know if the hatch your talking about is under them?

I have a 2001 (2510 Parker ) with twin Yamahas. My fuel gauge is blinking with one bar. Can someone please tell me where the fuel sending unit is located.please be specific. The boat original seats wave been altered with a plate on the deck and shock seats. I don't know is a hatch used to be...

I am located in Los Angeles . I have sold everything except the rocket launcher $350

I am selling : 1 rocket launcher $350 2 seats with place for rod & pedestal(both) $250 2 seat base with storage & base (both) $300 Ray ([email protected])

I have a 2001 Parker 2510 DV w/twin Yamaha 200-2 stroke (HPDI) engines, I am hoping you can help me with info on fuel capacity and range.( 2-3 ft seas, normal cruising speed )What is the average Range on a full tankl. any feedback is appreciated.

How can I visibly , tell the difference between a Parker deep V and a modified V.

I have some scratches and discoloration on my 2510 deck. I dont whant to re-gel it. Its not that bad. What can I use please help.