Search results

I have a 2003 2510 and am ready for a possible repower as I like to go far out and need the speed. My current 225 is ok but again I only go on calm days so would like the piece of mind of new power with more speed. My Parker has a max HP plate of 325 on the boat. I don't know if I ever seen one...

I have a problem with the overheat alarm. It only happens at low rpm in a trailing sea. The pisser tube is not flowing hard like it should so I replaced the water pump impeller but it made no difference and the impeller looked fine. I am Thinking that the theromostat might need replacing. What...

I am thinking about purchasing a trailer for my 2510. What model and size should I get?

i just purchased a new s1000 and installed it as recogmended . I installed it behind the stearing station on my 2510 inside the fiberglass electrical box. The problem is that when I am standing at the rear of the boat 8 feet away the system looses signal from the remote and it goes into...

I up graded my trim tabs with 12X18 blades on my 2510 and the other day I noticed that the port blade was dangleing. After further inspection I found that the hinge pin was gone. There was a rust stain at the hinge. Did the pin rust away, the tabs are less than 6 months old. Did Lenco not use...

I found some water inside one of my tabs and want to replace the motor before spring dump. does anyone know of where I can purchase just the motor. Lenco only wants to sell me the whole new actuator. Thanks, paul

Just installed a new Yamaha fuel management sysytem on my 2510 with a single 225. I went with the yamaha system because it matched the other guages and I firured it would be easier to install and interface, but Im having some issues and could use some help. I hooked all the wires comming from...

I am trying to find out if the factory 17 3 blade black prop on my F225 2510 MV is the best prop for the boat. I have read a lot of info on other boats , the 2520 Dv and others but not much on the 2510 MV bracket mount. I am looking for economy first as I usually am underloaded, and like to go...

This is my first oil change since purchase last year on a 225 4stroke on a 2510 2003. What type and weight oil should I use. I did not get a motor manual with the boat. Also how about the gear lube? Anything else?

I need some advice on what type and what location to mount some interior rod holders on my 2510. I was thinking somewhere on the ceiling or on the sides near the ceiling. How thick is the fiberglass and what size attaching screws can be used without going through. Second project is to install a...

I finally after many years of looking for the perfit boat decided to buy a 2510 Parker. I bought it used from a guy in annapolis. The boat is a 2003 2510 MV and had been lift kept since new. I picked the boat up last friday afternoon in annapolis and headed south to Solomons for the start of...