Just installed a transducer inside boat in a round PVC pipe. My instructions said to epoxy it in. Seem like a waste if I wanted to remove the transducer from epoxy. I put water in pipe and used flower clay to hold it down, works like a charm. Just a suggestion.
inside Transducer
- Thread starter boat25
- Start date
Help Support Classic Parker Boat Forum:
I second that suggestion! 
I just today finished a project to mount a 3D transducer array (roughly 3"X5" square) inside the hull in a "box" filled with seawater.
Works very slick. No epoxy on the transducer, and it's sitting out of harm's way in it's own cozy little water-box in the bilge.
I will post the project in the new electronics forum later on.
I just today finished a project to mount a 3D transducer array (roughly 3"X5" square) inside the hull in a "box" filled with seawater. Works very slick. No epoxy on the transducer, and it's sitting out of harm's way in it's own cozy little water-box in the bilge.
I will post the project in the new electronics forum later on.
